ASTM E 1002 : 2011 : R2022
Current
The latest, up-to-date edition.
Standard Practice for Leaks Using Ultrasonics
Hardcopy , PDF
English
07-06-2022
Committee |
E 07
|
DocumentType |
Standard Practice
|
Pages |
4
|
PublisherName |
American Society for Testing and Materials
|
Status |
Current
|
Supersedes |
1.1Practice A, Pressurization—This practice covers procedures for calibration of ultrasonic instruments, location, and estimated measurements of gas leakage to atmosphere by the airborne ultrasonic technique.2
1.2In general practice this should be limited to leaks detected by two classifications of instruments, Class I and Class II. Class I instruments should have a minimum detectable leak rate of 6.7 × 10−7 mol/s (1.5 × 10 −2 std. cm3/s at 0°C) or more for the pressure method of gas leakage to atmosphere. Class II instruments should have a minimal detectable leak rate of 6.7 × 10 −6 mol/s (1.5 × 10−1 std. cm3/s at 0°C) or more for the pressure method of gas leakage to atmosphere. Refer to Guide E432 for additional information.
1.3Practice B, Ultrasonic Transmitter—For object under test not capable of being pressurized but capable of having ultrasonic tone placed/injected into the test area to act as an ultrasonic leak trace source.
1.3.1This practice is limited to leaks producing leakage of 6.7 × 10−6 mol/s (1.5 × 10 −1 std. cm3/s at 0°C) or greater.
1.4The values stated in SI units are to be regarded as the standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E 2533 : 2021 | Standard Guide for Nondestructive Examination of Polymer Matrix Composites Used in Aerospace Applications |
ASTM E 1066/E1066M : 2019 | Standard Practice for Ammonia Colorimetric Leak Testing |
ASTM E 1211/E1211M : 2017 | Standard Practice for Leak Detection and Location Using Surface-Mounted Acoustic Emission Sensors |
ASTM E 1316 : 2022 : REV A | Standard Terminology for Nondestructive Examinations |
ASTM E 432 : 1991 : R2017 : EDT 1 | Standard Guide for Selection of a Leak Testing Method |
ASTM E 1316 : 2024 : REV B | Standard Terminology for Nondestructive Examinations |
ASTM E 1316 : 2024 | Standard Terminology for <?Pub Dtl?>Nondestructive Examinations |
ASTM E 1316 : 2023 : REV A | Standard Terminology for Nondestructive Examinations |
ASTM E 1316 : 2024 : REV A | Standard Terminology for Nondestructive Examinations |
ASTM E 1316 : 2023 | Standard Terminology for Nondestructive Examinations |
ASTM E 1316 : 2023 : REV B | Standard Terminology for Nondestructive Examinations |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.