ASTM D 6875 : 2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor
Hardcopy , PDF
11-11-2014
English
10-01-2008
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 16
|
| DocumentType |
Test Method
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This test method covers a general procedure for determining the solidification point of most organic chemicals having appreciable heats of fusion and solidification points between 4 and 41°C.
Note 1—Other test methods for determining freeze point and solidification point of aromatic hydrocarbons include Test Methods D 852
1.2 This test method is applicable to relatively pure compounds only. Solidification point depression is dependent on impurity concentrations.
1.3 The following applies to all specified limits in this test method: for purposes of determining conformance with applicable specifications using this test method, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right hand digit used in expressing the specification limit, in accordance with the “rounding-off method” of Practice E 29
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 8, Hazards.
| ASTM D 2359 : 2018 : REV A | Standard Specification for Refined Benzene-535 |
| ASTM D 4734 : 2018 : REV A | Standard Specification for Refined Benzene-545 |
| ASTM D 5871 : 2017 | Standard Specification for Benzene for Cyclohexane Feedstock |
| ASTM D 7185 : 2017 | Standard Specification for Low Toluene Low Dioxane (LTLD) Benzene |
| ASTM D 2439 : 2016 | Standard Specification for Refined Phenol |
| ASTM E 324 : 2016 | Standard Test Method for Relative Initial and Final Melting Points and the Melting Range of Organic Chemicals |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.