ASTM D 5711 : 2003
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Standard Test Method for Determining the Adherent Coating on Coarse Aggregates (Withdrawn 2012)
Hardcopy , PDF
01-31-2012
English
07-10-2003
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.03, 2009 Determines the percent by mass of fine dust, clay or silt, or both, present as a coating on coarse aggregate particles. The nature of the fines adhering to the coarse aggregate is not determined.
| Committee |
D 04
|
| DocumentType |
Test Method
|
| Pages |
2
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Withdrawn
|
| Supersedes |
1.1 This test method is used to determine the adherent coating on coarse aggregate (aggregate retained on the 2.36-mm (No. 8) sieve) for the following purposes:
1.1.1 Preliminary investigation of mineral aggregate sources.
1.1.2 Control of mineral aggregates used in hot mix asphalt (HMA) pavements, seal coats, cover coats, surface treatments, cold mix asphalt, and portland cement concrete at the source of supply.
1.1.3 Control of mineral aggregate processing requirements.
1.1.4 Acceptance or rejection of aggregates based on adherent coating.
1.2 The values shown in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—This test method is modeled after Federal Land Highways T 512-94.
| ASTM D 5106 : 2015 : REDLINE | Standard Specification for Steel Slag Aggregates for Bituminous Paving Mixtures |
| ASTM D 5106 : 2015 | Standard Specification for Steel Slag Aggregates for Bituminous Paving Mixtures |
| ASTM D 6155 : 2015 | Standard Specification for Nontraditional Coarse Aggregates for Bituminous Paving Mixtures |
| ASTM D 75 : 2003 | Standard Practice for Sampling Aggregates |
| ASTM C 702 : 1998 | Standard Practice for Reducing Samples of Aggregate to Testing Size |
| ASTM D 2419 : 2014 : REDLINE | Standard Test Method for Sand Equivalent Value of Soils and Fine Aggregate |
| ASTM C 136 : 2006 | Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates |
| ASTM E 11 : 2017 : REDLINE | Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.