ASTM D 5315 : 2004 : R2017 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Determination of N-Methyl-Carbamoyloximes and N-Methylcarbamates in Water by Direct Aqueous Injection HPLC with Post-Column Derivatization
Hardcopy , PDF
05-06-2024
English
01-05-2018
CONTAINED IN VOL. 11.02, 2018 Defines a high-performance liquid chromatographic (HPLC) test method applicable to the determination of certain n-methylcarbamoyloximes and n-methylcarbamates in ground water and finished drinking water.
Committee |
D 19
|
DocumentType |
Test Method
|
Pages |
16
|
ProductNote |
Reconfirmed EDT 1
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1This is a high-performance liquid chromatographic (HPLC) test method applicable to the determination of certain n-methylcarbamoyloximes and n-methylcarbamates in ground water and finished drinking water (1).2 This test method is applicable to any carbamate analyte that can be hydrolyzed to a primary amine. The following compounds have been validated using this test method:
Analyte | Chemical Abstract Services |
Aldicarb | 116-06-3 |
Aldicarb sulfone | 1646-88-4 |
Aldicarb sulfoxide | 1646-87-3 |
Baygon | 114-26-1 |
Carbaryl | 63-25-2 |
Carbofuran | 1563-66-2 |
3-Hydroxycarbofuran | 16655-82-6 |
Methiocarb | 2032-65-7 |
Methomyl | 16752-77-5 |
Oxamyl | 23135-22-0 |
1.2This test method has been validated in a collaborative round-robin study (2) and estimated detection limits (EDLs) have been determined for the analytes listed in 1.1 (Table 1). Observed detection limits may vary between ground waters, depending on the nature of interferences in the sample matrix and the specific instrumentation used.
1.3This test method is restricted to use by, or under the supervision of, analysts experienced in both the use of liquid chromatography and the interpretation of liquid chromatograms. Each analyst should demonstrate an ability to generate acceptable results with this test method using the procedure described in 12.3.
1.4When this test method is used to analyze unfamiliar samples for any or all of the analytes listed in 1.1, analyte identifications should be confirmed by at least one additional qualitative technique.
1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Additional guidance on laboratory safety is available and suitable references for the information are provided (3-5).
1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D 3694 : 1996 : R2017 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM D 3694 : 1996 : R2024 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM D 3694 : 1996 : R2011 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM D 3370 : 1995 : REV A : R2003 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
ASTM D 1129 : 2013 : REDLINE | Standard Terminology Relating to Water |
ASTM D 1129 : 2003 | Standard Terminology Relating to Water |
ASTM D 2777 : 2013 : REDLINE | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
ASTM D 1129 : 2013 | Standard Terminology Relating to Water |
ASTM D 1129 : 2013 : R2020 | Standard Terminology Relating to Water |
ASTM D 3694 : 1996 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM D 2777 : 2012 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
ASTM D 1129 : 2013 : R2020 : EDT 2 | Standard Terminology Relating to Water |
ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
ASTM D 1129 : 2006 | Standard Terminology Relating to Water |
ASTM D 2777 : 2003 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
ASTM D 2777 : 2021 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
ASTM D 3370 : 2010 | Standard Practices for Sampling Water from Closed Conduits |
ASTM D 2777 : 2013 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
ASTM D 2777 : 1998 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
ASTM D 3694 : 1996 : R2017 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM E 682 : 1992 | Standard Practice for Liquid Chromatography Terms and Relationships |
ASTM D 1129 : 2013 : R2020 : EDT 1 | Standard Terminology Relating to Water |
ASTM D 3370 : 2008 | Standard Practices for Sampling Water from Closed Conduits |
ASTM D 1129 : 1999 : REV A | Standard Terminology Relating to Water |
ASTM D 1129 : 2006 : REV A | Standard Terminology Relating to Water |
ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
ASTM D 1129 : 2003 : REV A | Standard Terminology Relating to Water |
ASTM D 3694 : 1996 : R2004 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM D 1129 : 2002 | Standard Terminology Relating to Water |
ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
ASTM D 1129 : 2004 | Standard Terminology Relating to Water |
ASTM D 2777 : 2008 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
ASTM D 1192 : 1998 | Standard Guide for Equipment for Sampling Water and Steam in Closed Conduits (Withdrawn 2003) |
ASTM D 2777 : 2006 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
ASTM D 3370 : 2018 | Standard Practices for Sampling Water from Flowing Process Streams |
ASTM D 1129 : 2002 : REV A | Standard Terminology Relating to Water |
ASTM D 3370 : 1976 | Standard Practices for Sampling Water |
ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
ASTM D 3370 : 1995 : REV A : R1999 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
ASTM E 682 : 1992 : R2000 | Standard Practice for Liquid Chromatography Terms and Relationships |
ASTM D 1129 : 2010 | Standard Terminology Relating to Water |
ASTM D 3370 : 2007 | Standard Practices for Sampling Water from Closed Conduits |
ASTM D 1129 : 2006 : REV A : EDT 1 | Standard Terminology Relating to Water |
ASTM D 1129 : 2001 | Standard Terminology Relating to Water |
ASTM D 1129 : 2004 : EDT 1 | Standard Terminology Relating to Water |
ASTM D 3694 : 1996 : R2024 | Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents |
ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
ASTM D 2777 : 2008 : EDT 1 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.