ASTM D 4587 : 2011 : R2019 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Practice for Fluorescent UV-Condensation Exposures of Paint and Related Coatings
12-24-2019
12-24-2019
| Committee |
D 01
|
| DocumentType |
Standard Practice
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| Supersedes |
1.1This practice covers the selection of test conditions for accelerated exposure testing of coatings and related products in fluorescent UV and condensation devices conducted according to Practices G151 and G154. This practice also covers the preparation of test specimens, and the evaluation of test results. Table 1 describes commonly used test conditions.
Note 1:Previous versions of this practice referenced fluorescent UV devices described by Practice G53, which described very specific equipment designs. Practice G53 has been withdrawn and replaced by Practice G151, which describes performance criteria for all exposure devices that use laboratory light sources, and by Practice G154, which gives requirements for exposing nonmetallic materials in fluorescent UV devices.
Note 2:ISO 11507:1997 also describes fluorescent UV-condensation exposures of paints and coatings.
1.2The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 5894 : 2021 | Standard Practice for Cyclic Salt Fog/UV Exposure of Painted Metal, (Alternating Exposures in a Fog/Dry Cabinet and a UV/Condensation Cabinet) |
| ASTM D 5590 : 2017 : R2021 | Standard Test Method for Determining the Resistance of Paint Films and Related Coatings to Fungal Defacement by Accelerated Four-Week Agar Plate Assay |
| ASTM D 6578/D6578M : 2013 : R2018 | Standard Practice for Determination of Graffiti Resistance |
| ASTM D 1654 : 2008 : R2016 : EDT 1 | Standard Test Method for Evaluation of Painted or Coated Specimens Subjected to Corrosive Environments |
| ASTM D 3451 : 2006 : R2017 | Standard Guide for Testing Coating Powders and Powder Coatings |
| ASTM D 5589 : 2019 | Standard Test Method for Determining the Resistance of Paint Films and Related Coatings to Algal Defacement |
| ASTM D 6763 : 2016 : R2022 | Standard Guide for Testing Exterior Wood Stains and Clear Water Repellents |
| ASTM D 3794 : 2022 | Standard Guide for Testing Coil Coatings |
| ASTM D 6577 : 2015 : R2019 | Standard Guide for Testing Industrial Protective Coatings |
| ASTM G 178 : 2016 : R2023 | Standard Practice for Determining the Activation Spectrum of a Material (Wavelength Sensitivity to an Exposure Source) Using the Sharp Cut-On Filter or Spectrographic Technique |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.