ASTM D 3933 : 1998 : R2004
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Preparation of Aluminum Surfaces for Structural Adhesives Bonding (Phosphoric Acid Anodizing)
Hardcopy , PDF
11-11-2014
English
04-01-2004
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 15.06, 2017 Specifies the requirements for phosphoric acid anodizing of aluminum and its alloys for structural adhesive bonding.
| Committee |
D 14
|
| DocumentType |
Guide
|
| Pages |
5
|
| ProductNote |
Reconfirmed 2004
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This guide describes the requirements for phosphoric acid anodizing of aluminum and its alloys for structural adhesive bonding.
1.2 The procedure included herein is based on the commercial practice of numerous agencies and organizations. The method may be revised or supplemented, as necessary, to include methods based on proven performance.
1.3 The surface preparation of metal systems used for qualification and quality-control testing of the adhesive should be agreed upon between the manufacturer and the user.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precaution is given in 5.5.
| ASTM D 6465 : 1999 : R2016 | Standard Guide for Selecting Aerospace and General Purpose Adhesives and Sealants |
| ASTM D 2651 : 2001 : R2016 | Standard Guide for Preparation of Metal Surfaces for Adhesive Bonding |
| ASTM D 4541 : 2017 | Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers |
| ASTM D 7234 : 2012 | Standard Test Method for Pull-Off Adhesion Strength of Coatings on Concrete Using Portable Pull-Off Adhesion Testers |
| ASTM D 3165 : 2007 : R2014 | Standard Test Method for Strength Properties of Adhesives in Shear by Tension Loading of Single-Lap-Joint Laminated Assemblies |
| ASTM D 907 : 2015 : REDLINE | Standard Terminology of Adhesives |
| O-O-670 Revision C:1991 | ORTHOPHOSPHORIC (PHOSPHORIC) ACID, TECHNICAL |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.