ASTM D 3912 : 2010 : R2023
Current
The latest, up-to-date edition.
Standard Test Method for Chemical Resistance of Coatings and Linings for Use in Nuclear Power Plants
Hardcopy , PDF
English
05-01-2023
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 33
|
| DocumentType |
Test Method
|
| Pages |
2
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This test method establishes procedures for the evaluation of the chemical resistance of coatings and linings for use in Coating Service Level I and II applications in nuclear power plants.
1.2This test method is intended to be used as a screening test to evaluate coatings and linings on steel and concrete substrates.
1.3This test method addresses two exposure intervals:
(1)Short Term (Typically 5 days): Such exposures are primarily applicable for coatings exposed to chemical splash or spill.
(2)Long Term (Typically 180 days): Such exposures are primarily applicable for linings exposed to continuous or near-continuous chemical immersion.
1.4The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 8157 : 2019 | Standard Guide for Qualification Testing of Coatings Used in Coating Service Level I in Nuclear Power Plants |
| ASTM D 5144 : 2008 : R2021 | Standard Guide for Use of Protective Coating Standards in Nuclear Power Plants |
| ASTM D 6577 : 2015 : R2019 | Standard Guide for Testing Industrial Protective Coatings |
| ASTM D 5139 : 2019 | Standard Specification for Sample Preparation for Qualification Testing of Coatings to be Used in Nuclear Power Plants |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.