ASTM D 228/D228M : 2021
Current
The latest, up-to-date edition.
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
Hardcopy , PDF
English
02-18-2021
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 08
|
| DocumentType |
Test Method
|
| Pages |
13
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1These test methods cover procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials is allowed to be partially or fully coated, surfaced, or laminated, or a combination thereof.
1.2The test methods and procedures in this standard appear in the following order:
| Section | Content |
| 6 | Types of Roofing |
| 7 | Sampling |
| 8 | Mass and Area Determination |
| 9 | Selection of Representative Specimens |
| 10 | Moisture |
| 11 | Pliability |
| 12 | Mass Loss and Behavior on Heating |
| 13 | Tear Strength |
| 14 | Fastener Pull-Through Resistance |
| 15 | Preparation and Selection of Small Test Specimens |
| 16 | Analysis of Glass Felt Products |
| 17 | Analysis of Roofing Products with Organic Felts |
| 18 | Ash of Desaturated Felt |
| 19 | Calculation |
| 20 | Adjusting Back Coating Fine Mineral Matter and |
| 21 | Report |
| 22 | Precision and Bias |
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 4897/D4897M : 2016 | Standard Specification for Asphalt-Coated Glass-Fiber Venting Base Sheet Used in Roofing |
| ASTM D 7158/D7158M : 2020 | Standard Test Method for Wind Resistance of Asphalt Shingles (Uplift Force/Uplift Resistance Method) |
| ASTM D 4601/D4601M : 2004 : R2020 | Standard Specification for Asphalt-Coated Glass Fiber Base Sheet Used in Roofing |
| ASTM D 3462/D3462M : 2019 | Standard Specification for Asphalt Shingles Made from Glass Felt and Surfaced with Mineral Granules |
| ASTM D 6381/D6381M : 2015 : R2020 | Standard Test Method for Measurement of Asphalt Shingle Mechanical Uplift Resistance |
| ASTM D 3105 : 2017 | Standard Index of Methods for Testing Elastomeric and Plastomeric Roofing and Waterproofing Materials |
| ASTM D 1970/D1970M : 2020 | Standard Specification for Self-Adhering Polymer Modified Bituminous Sheet Materials Used as Steep Roofing Underlayment for Ice Dam Protection |
| ASTM D 2626/D2626M : 2004 : R2020 | Standard Specification for Asphalt-Saturated and Coated Organic Felt Base Sheet Used in Roofing |
| ASTM D 6380/D6380M : 2003 : R2018 | Standard Specification for Asphalt Roll Roofing (Organic Felt) |
| ASTM D 3018/D3018M : 2011 : R2017 | Standard Specification for Class A Asphalt Shingles Surfaced with Mineral Granules |
| ASTM D 6757/D6757M : 2018 | Standard Specification for Underlayment Felt Containing Inorganic Fibers Used in Steep-Slope Roofing |
| ASTM D 8257/D8257M : 2020 | Standard Specification for Mechanically Attached Polymeric Roof Underlayment Used in Steep Slope Roofing |
| ASTM D 95 : 2023 : EDT 1 | Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation |
| ASTM D 3909/D3909M : 2014 : R2021 | Standard Specification for Asphalt Roll Roofing (Glass Felt) Surfaced with Mineral Granules |
| ASTM D 3909/D3909M : 2022 | Standard Specification for Asphalt Roll Roofing (Glass Felt) Surfaced with Mineral Granules |
| ASTM D 1079 : 2020 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 1922 : 2023 | Standard Test Method for Propagation Tear Resistance of Plastic Film and Thin Sheeting by Pendulum Method |
| ASTM D 3462/D3462M : 2023 | Standard Specification for Asphalt Shingles Made from Glass Felt and Surfaced with Mineral Granules |
| ASTM D 2178/D2178M : 2015 : REV A : R2021 | Standard Specification for Asphalt Glass Felt Used in Roofing and Waterproofing |
| ASTM D 4897/D4897M : 2016 : R2023 | Standard Specification for Asphalt-Coated Glass-Fiber Venting Base Sheet Used in Roofing |
| ASTM D 6380/D6380M : 2003 : R2022 | Standard Specification for Asphalt Roll Roofing (Organic Felt) |
| ASTM F 1667 : 2021 | Standard Specification for Driven Fasteners: Nails, Spikes, and Staples |
| ASTM D 95 : 2013 : R2018 | Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation |
| ASTM F 1667 : 2020 | Standard Specification for Driven Fasteners: Nails, Spikes, and Staples |
| ASTM D 4932/D4932M : 1989 : R2024 | Standard Test Method for Fastener Rupture and Tear Resistance of Roofing and Waterproofing Sheets, Roll Roofing, and Shingles |
| ASTM D 3909/D3909M : 2014 | Standard Specification for Asphalt Roll Roofing (Glass Felt) Surfaced With Mineral Granules |
| ASTM D 1922 : 2015 : R2020 | Standard Test Method for Propagation Tear Resistance of Plastic Film and Thin Sheeting by Pendulum Method |
| ASTM D 2178/D2178M : 2015 : REV A | Standard Specification for Asphalt Glass Felt Used in Roofing and Waterproofing |
| ASTM D 4932/D4932M : 1989 : R2019 | Standard Test Method for Fastener Rupture and Tear Resistance of Roofing and Waterproofing Sheets, Roll Roofing, and Shingles |
| ASTM D 1079 : 2024 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 6380/D6380M : 2003 : R2018 | Standard Specification for Asphalt Roll Roofing (Organic Felt) |
| ASTM D 95 : 2023 | Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.