ASTM D 2162 : 2017
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards
Available format(s)
Hardcopy , PDF
Superseded date
04-15-2021
Superseded by
Language(s)
English
Published date
05-10-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 02
|
| DocumentType |
Standard Practice
|
| Pages |
8
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This practice covers the calibration of master viscometers and viscosity oil standards, both of which may be used to calibrate routine viscometers as described in Test Method D445 and Specifications D446 over the temperature range from 15 °C to 100 °C.
1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1The SI-based units for calibration constants and kinematic viscosities are mm2/s2 and mm 2/s, respectively.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 7483 : 2013 : REV A : R2017 | Standard Test Method for Determination of Dynamic Viscosity and Derived Kinematic Viscosity of Liquids by Oscillating Piston Viscometer |
| ASTM D 7945 : 2016 | Standard Test Method for Determination of Dynamic Viscosity and Derived Kinematic Viscosity of Liquids by Constant Pressure Viscometer |
| ASTM D 445 : 2019 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) |
| ASTM D 446 : 2012 : R2017 | Standard Specifications and Operating Instructions for Glass Capillary Kinematic Viscometers |
| ASTM D 5293 : 2017 : REV A | Standard Test Method for Apparent Viscosity of Engine Oils and Base Stocks Between –10 °C and –35 °C Using Cold-Cranking Simulator |
| ASTM D 7279 : 2018 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids by Automated Houillon Viscometer |
| ASTM D 2983 : 2019 | Standard Test Method for Low-Temperature Viscosity of Automatic Transmission Fluids, Hydraulic Fluids, and Lubricants using a Rotational Viscometer |
| ASTM D 445 : 2019 : REV A | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) |
| ASTM D 2983 : 2020 | Standard Test Method for Low-Temperature Viscosity of Automatic Transmission Fluids, Hydraulic Fluids, and Lubricants using a Rotational Viscometer |
| ASTM D 8210 : 2020 | Standard Test Method for Automatic Determination of Low-Temperature Viscosity of Automatic Transmission Fluids, Hydraulic Fluids, and Lubricants Using a Rotational Viscometer |
| ASTM D 5293 : 2020 | Standard Test Method for Apparent Viscosity of Engine Oils and Base Stocks Between –10 °C and –35 °C Using Cold-Cranking Simulator |
| ASTM D 7945 : 2021 | Standard Test Method for Determination of Dynamic Viscosity and Derived Kinematic Viscosity of Liquids by Constant Pressure Viscometer |
| ASTM D 789 : 2019 | Standard Test Method for Determination of Relative Viscosity of Concentrated Polyamide (PA) Solutions |
| ASTM D 7483 : 2021 | Standard Test Method for Determination of Dynamic Viscosity and Derived Kinematic Viscosity of Liquids by Oscillating Piston Viscometer |
| ASTM D 7279 : 2020 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids by Automated Houillon Viscometer |
| ASTM D 7042 : 2021 | Standard Test Method for Dynamic Viscosity and Density of Liquids by Stabinger Viscometer (and the Calculation of Kinematic Viscosity) |
| ASTM D 8278 : 2020 | Standard Specification for Digital Contact Thermometers for Test Methods Measuring Flow Properties of Fuels and Lubricants |
| ASTM D 789 : 2018 | Standard Test Method for Determination of Relative Viscosity of Concentrated Polyamide (PA) Solutions |
| ASTM D 4486 : 2018 | Standard Test Method for Kinematic Viscosity of Volatile and Reactive Liquids |
| ASTM D 8092 : 2017 | Standard Test Method for Field Determination of Kinematic Viscosity Using a Microchannel Viscometer |
| ASTM D 7042 : 2016 : EDT 3 | Standard Test Method for Dynamic Viscosity and Density of Liquids by Stabinger Viscometer (and the Calculation of Kinematic Viscosity) |
| ASTM D 2170/D2170M : 2018 | Standard Test Method for Kinematic Viscosity of Asphalts |
| ASTM E 563 : 1997 | Standard Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature |
| ASTM E 2877 : 2012 : EDT 1 | Standard Guide for Digital Contact Thermometers |
| ASTM E 1750 : 1995 | Standard Guide for Use of Water Triple Point Cells |
| ASTM D 1250 : 2007 | Standard Guide for Use of the Petroleum Measurement Tables |
| ASTM E 2593 : 2011 : EDT 1 | Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers |
| ASTM D 1250 : 2019 : EDT 1 | Standard Guide for the Use of the Joint API and ASTM Adjunct for Temperature and Pressure Volume Correction Factors for Generalized Crude Oils, Refined Products, and Lubricating Oils: API MPMS Chapter 11.1 |
| ASTM E 1750 : 2009 | Standard Guide for Use of Water Triple Point Cells |
| ASTM D 1250 : 2008 : R2013 | Standard Guide for Use of the Petroleum Measurement Tables |
| ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
| ASTM D 1480 : 2015 | Standard Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer |
| ASTM D 1250 : 2004 | Standard Guide for Use of the Petroleum Measurement Tables |
| ASTM D 1250 : 1980 : R2002 | Standard Guide for Petroleum Measurement Tables |
| ASTM D 1250 : 2019 | Standard Guide for the Use of the Joint API and ASTM Adjunct for Temperature and Pressure Volume Correction Factors for Generalized Crude Oils, Refined Products, and Lubricating Oils: API MPMS Chapter 11.1 |
| ASTM E 1750 : 2002 | Standard Guide for Use of Water Triple Point Cells |
| ASTM E 2593 : 2012 | Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers |
| ASTM E 2593 : 2007 | Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers |
| ASTM E 2593 : 2017 | Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers |
| ASTM D 1480 : 2002 | Standard Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer |
| ASTM D 1250 : 1980 : R1997 : EDT 1 | Standard Guide for Petroleum Measurement Tables |
| ASTM D 445 : 1988 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation of Dynamic Viscosity) |
| ASTM D 1250 : 2008 | Standard Guide for Use of the Petroleum Measurement Tables |
| ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
| ASTM E 2593 : 2011 | Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers |
| ASTM E 2877 : 2012 : R2019 | Standard Guide for Digital Contact Thermometers |
| ASTM D 1480 : 2007 | Standard Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer |
| ASTM D 1480 : 2012 | Standard Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer |
| ASTM D 1480 : 2002 : EDT 1 | Standard Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer |
| ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
| ASTM D 1590 : 1960 : R1977 | Test Methods for Surface Tension of Water and Waste Water (Withdrawn 1995) |
| ASTM E 2877 : 2012 | Standard Guide for Standard Guide for Digital Contact Thermometers |
| ASTM D 445 : 2001 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (the Calculation of Dynamic Viscosity) |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
| ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
| ASTM D 1250 : 2008 : R2013 : EDT 1 | Standard Guide for Use of the Petroleum Measurement Tables |
| ASTM E 2593 : 2007 : EDT 1 | Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers |
| ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
| ASTM D 1480 : 1993 : R1997 | Standard Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer |
| ASTM E 1137 : 1997 | Standard Specification for Industrial Platinum Resistance Thermometers |
| ASTM E 1750 : 2010 | Standard Guide for Use of Water Triple Point Cells |
| ASTM E 1750 : 2010 : R2016 | Standard Guide for Use of Water Triple Point Cells |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.