ASTM D 1896 : 2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds
Hardcopy , PDF
11-11-2014
English
12-01-2009
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 08.01, 2009 Gives a general procedure covering the transfer molding of mechanical and electrical test specimens in thermosetting molding materials.
| Committee |
D 20
|
| DevelopmentNote |
Supersedes ASTM D 647 (12/2001)
|
| DocumentType |
Standard Practice
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This practice covers a general procedure for the transfer molding of mechanical and electrical test specimens of thermosetting molding materials.
Note 1—The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting intermediate viscosity non-Newtonian flow.
1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system are not always exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this practice.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 2—There is no known ISO equivalent to this standard.
| ASTM D 5948 : 2005 : R2012 | Standard Specification for Molding Compounds, Thermosetting |
| ASTM D 6289 : 2013 : R2019 | Standard Test Method for Measuring Shrinkage from Mold Dimensions of Molded Thermosetting Plastics |
| ASTM D 5948 : 2005 | Standard Specification for Molding Compounds, Thermosetting |
| ASTM D 704 : 1999 | Standard Specification for Melamine-Formaldehyde Molding Compounds |
| ASTM D 704 : 1999 : R2012 | Standard Specification for Melamine-Formaldehyde Molding Compounds |
| ASTM D 651 : 1984 | Method of Test for Tensile Strength of Molded Electrical Insulating Materials (Withdrawn 1989) |
| ASTM D 3013 : 2013 : REDLINE | Standard Specification for Epoxy Molding Compounds |
| ASTM D 704 : 1999 : R2004 | Standard Specification for Melamine-Formaldehyde Molding Compounds |
| ASTM D 4617 : 2003 | Standard Classification System for Phenolic Compounds (PF) (Withdrawn 2012) |
| ASTM D 3013 : 2013 | Standard Specification for Epoxy Molding Compounds |
| ASTM D 5948 : 2005 : EDT 1 | Standard Specification for Molding Compounds, Thermosetting |
| ASTM D 957 : 2012 : REDLINE | Standard Practice for Determining Surface Temperature of Molds for Plastics |
| ASTM D 731 : 2010-07 | TEST METHOD FOR MOLDING INDEX OF THERMOSETTING MOLDING POWDER |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.