ASTM C 1298 : 1995 : R2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Design and Construction of Brick Liners for Industrial Chimneys
Hardcopy , PDF
11-11-2014
English
12-01-2007
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.05, 2015 Gives procedures for the design and construction of brick liners for industrial chimneys.
| Committee |
C 15
|
| DocumentType |
Guide
|
| Pages |
13
|
| ProductNote |
Reconfirmed 2007
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This guide covers procedures for the design, construction, and serviceability of brick liners for industrial chimneys. The structural design criteria are applicable to vertical masonry cantilever structures supported only at their base, either by a foundation, a concrete pedestal, or by some means from the outer concrete shell. Excluded from direct consideration are single-wythe, sectional brick linings that are supported on a series of corbels cast in the outer chimney shell.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ANSI/ASCE 7 88 : 1990 | MINIMUM DESIGN LOADS FOR BUILDINGS AND OTHER STRUCTURES |
| ASTM C 980 : 2017 : REDLINE | Standard Specification for Industrial Chimney Lining Brick |
| ACI 307 : 2008 | DESIGN AND CONSTRUCTION OF REINFORCED CONCRETE CHIMNEYS AND COMMENTARY |
| ASTM E 111 : 2017 : REDLINE | Standard Test Method for Young’s Modulus, Tangent Modulus, and Chord Modulus |
| ASTM E 447 : 1997 | Test Methods for Compressive Strength of Laboratory Constructed Masonry Prisms (Withdrawn 1998) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.