ASTM C 1193 : 2013

1.1This guide describes the use of a cold liquid-applied sealant for joint sealing applications. Including joints on buildings and related adjacent areas, such as plazas, decks, and pavements for vehicular or pedestrian use, and types of construction other than highways and airfield pavements and bridges. Information in this guide is primarily applicable to a single and multi-component, cold liquid-applied joint sealant and secondarily to a precured sealant when used with a properly prepared joint opening and substrate surfaces.

1.2An elastomeric or non-elastomeric sealant described by this guide should meet the requirements of Specification C834, C920, or C1311.

1.3This guide does not provide information or guidelines for the use of a sealant in a structural sealant glazing application. Guide C1401 should be consulted for this information. Additionally, it also does not provide information or guidelines for the use of a sealant in an insulating glass unit edge seal used in a structural sealant glazing application. Guide C1249 should be consulted for this information.

1.4Practice C919 should be consulted for information and guidelines for the use of a sealant in an application where an acoustic joint seal is required.

1.5This guide also does not provide information relative to the numerous types of sealant that are available nor specific generic sealant properties, such as hardness, tack-free time, or curing process, among others.

1.6The values stated in SI units are to be regarded as the standard. The values given in parenthesis are provided for information only.

1.7The Committee with jurisdiction for this standard is not aware of any comparable standards published by other organizations.

1.8This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

1.9The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations.