ASTM B 449 : 1993 : R1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Chromates on Aluminum
Hardcopy , PDF
11-11-2014
English
11-10-1998
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 02.05, 2017 Specifies the requirements relating to rinsed and nonrinsed chromate conversion coatings on aluminium and aluminium alloys intended to give protection against corrosion and as a base for other coatings.
| Committee |
B 08
|
| DocumentType |
Standard
|
| Pages |
5
|
| ProductNote |
Reconfirmed 1998
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This specification covers the requirements relating to rinsed and nonrinsed chromate conversion coatings on aluminum and aluminum alloys intended to give protection against corrosion and as a base for other coatings. This edition of the specification has been coordinated with ISO 10546 and is technically equivalent.
1.2 Aluminum and aluminum alloys are chromate coated in order to retard corrosion; as a base for organic films including paints, plastics, and adhesives; and as a protective coating having a low electrical contact impedance.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ISO 3892:2000 | Conversion coatings on metallic materials Determination of coating mass per unit area Gravimetric methods |
| MIL-DTL-5541 Revision F:2006 | Chemical Conversion Coatings on Aluminum and Aluminum Alloys |
| ISO 10546:1993 | Chemical conversion coatings Rinsed and non-rinsed chromate conversion coatings on aluminium and aluminium alloys |
| ISO 4519:1980 | Electrodeposited metallic coatings and related finishes — Sampling procedures for inspection by attributes |
| ISO 3768:1976 | Metallic coatings — Neutral salt spray test (NSS test) |
| ISO 2409:2013 | Paints and varnishes Cross-cut test |
| FED-STD-141 Revision D:2001 | PAINT, VARNISH, LACQUER AND RELATED MATERIALS, METHODS OF INSPECTION, SAMPLING AND TESTING |
| ASTM D 3359 : 2017 : REDLINE | Standard Test Methods for Rating Adhesion by Tape Test |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.