ASTM A 944 : 2010 : R2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Comparing Bond Strength of Steel Reinforcing Bars to Concrete Using Beam-End Specimens
Hardcopy , PDF
11-12-2022
English
11-09-2015
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 01.04, 2018 Specifies procedures to establish the relative bond strength of steel reinforcing bars in concrete.
| Committee |
A 01
|
| DocumentType |
Test Method
|
| Pages |
4
|
| ProductNote |
Reconfirmed 2015
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method describes procedures to establish the relative bond strength of steel reinforcing bars in concrete.
1.2This test method is intended to determine the effects of surface preparation or condition (such as bar coatings) on the bond strength of deformed steel reinforcing bars (of sizes ranging from No. 10 to No. 36 [No. 3 to No. 11]) to concrete.
1.3The bond strengths obtained using this test method are not directly applicable to the design of reinforced concrete members.
Note 1:The bond strengths obtained using this test method are generally higher than obtained in development or splice tests using beams with the same embedment lengths. The results obtained using this test method should only be used for comparisons with results for other reinforcing bars tested using this method.
1.4The values stated in inch-pound units are to be regarded as standard. The values given in brackets are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 7913/D7913M : 2014 : R2020 | Standard Test Method for Bond Strength of Fiber-Reinforced Polymer Matrix Composite Bars to Concrete by Pullout Testing |
| ASTM B 1009 : 2020 | Standard Specification for Titanium Alloy Bars for Near Surface Mounts in Civil Structures |
| ASTM A 775/A775M : 2022 | Standard Specification for Epoxy-Coated Steel Reinforcing Bars |
| ASTM A 934/A934M : 2022 | Standard Specification for Epoxy-Coated Prefabricated Steel Reinforcing Bars |
| ASTM A 1055/A1055M : 2022 | Standard Specification for Zinc and Epoxy Dual-Coated Steel Reinforcing Bars |
| ASTM C 192/C192M : 2000 | Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory |
| ASTM A 775/A775M : 2022 | Standard Specification for Epoxy-Coated Steel Reinforcing Bars |
| ASTM C 192/C192M : 2016-04 | PRACTICE FOR MAKING AND CURING CONCRETE TEST SPECIMENS IN THE LABORATORY |
| ASTM E 4 : 2021 | Standard Practices for Force Calibration and Verification of Testing Machines |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.