ASTM A 704/A704M : 2019 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement
Hardcopy , PDF
05-22-2024
English
12-04-2019
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
A 01
|
| DocumentType |
Standard
|
| Pages |
3
|
| ProductNote |
ε1 NOTE—An editorial correction was made to Footnote 1 in December 2019.
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification covers material in mat (or sheet) form fabricated from hot-rolled, plain steel bars or rods to be used for the reinforcement of concrete. Mats are made from two layers of bars or rods that are assembled by welding the intersections at right angles to each other.
1.2This specification is applicable for orders in either inch-pound units (as A704) or in SI units [as A704M].
1.3The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.
1.4This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM A 615/A615M : 2020 | Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement |
| ASTM A 706/A706M : 2022 | Standard Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement |
| ASTM A 615/A615M : 2022 | Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement |
| ASTM A 706/A706M : 2004 | Standard Specification for Low-Alloy Steel Deformed and Plain Bars for Concrete Reinforcement |
| ASTM A 1064/A1064M : 2018 : REV A | Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete |
| ASTM A 1064/A1064M : 2022 | Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete |
| ASTM A 1064/A1064M : 2024 | Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete |
| ASTM A 706/A706M : 2016 | Standard Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement |
| ASTM A 706/A706M : 2022 : REV A | Standard Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.