ASTM A 179/A179M : 2019
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Seamless Cold-Drawn Low-Carbon Steel Heat-Exchanger and Condenser Tubes
Hardcopy , PDF
03-14-2024
English
05-13-2019
Important note : All end users must be registered with an Account prior to user licenses being assigned.This specification covers minimum-wall thickness, seamless cold-drawn low-carbon steel tubes for tubular heat exchangers, condensers, and similar heat transfer apparatus.
| Committee |
A 01
|
| DocumentType |
Standard
|
| Pages |
3
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification2 covers minimum-wall-thickness, seamless cold-drawn low-carbon steel tubes for tubular heat exchangers, condensers, and similar heat transfer apparatus.
1.2This specification covers tubes 1/8to 3 in. [3.2 to 76.2 mm], inclusive, in outside diameter.
Note 1:Tubing smaller in outside diameter and having a thinner wall than indicated in this specification is available. Mechanical property requirements do not apply to tubing smaller than 1/8in. [3.2 mm] in outside diameter or with a wall thickness under 0.015 in. [0.4 mm].
1.3The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 3370 : 2018 | Standard Practices for Sampling Water from Flowing Process Streams |
| ASTM F 1155 : 2010 : R2019 | Standard Practice for Selection and Application of Piping System Materials |
| ASTM A 498/A498M : 2017 : R2023 | Standard Specification for Seamless and Welded Carbon Steel Heat-Exchanger Tubes with Integral Fins |
| ASTM A 450/A450M : 2002 | Standard Specification for General Requirements for Carbon, Ferritic Alloy, and Austenitic Alloy Steel Tubes |
| ASTM A 450/A450M : 2023 | Standard Specification for General Requirements for Carbon and Low Alloy Steel Tubes |
| ASTM A 450/A450M : 1996 : REV A : R2001 | Standard Specification for General Requirements for Carbon, Ferritic Alloy, and Austenitic Alloy Steel Tubes |
| ASTM A 450/A450M : 2021 | Standard Specification for General Requirements for Carbon and Low Alloy Steel Tubes |
| ASTM A 450/A450M : 2018 : REV A | Standard Specification for General Requirements for Carbon and Low Alloy Steel Tubes |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.