AS/NZS 1260:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PVC-U pipes and fittings for drain, waste and vent application
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
06-14-2024
06-16-2009
Important note : All end users must be registered with an Account prior to user licenses being assigned.Specifies requirements for PVC-U pipes and fittings for sewer, drain, waste and vent applications above ground or below ground and is intended to be used where the pipeline is operating under gravity flow and the operating pressure is low. The Standard includes requirements for both plain and structured wall pipes and fittings.
| Committee |
PL-021
|
| DocumentType |
Standard
|
| ISBN |
0 7337 9166 2
|
| Pages |
56
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This Standard specifies requirements for PVC-U pipes and fittings for sewer, drain, waste and vent applications above ground or below ground and is intended to be used where the pipeline is operating under gravity flow and the operating pressure is low. The Standard includes requirements for both plain and structured wall pipes and fittings. NOTE: Pipes manufactured to this Standard should be used and installed in accordance with AS/NZS 2032, AS/NZS 2566.1, AS/NZS 2566.2, AS/NZS 3500.2, AS/NZS 3500.5, WSA 02 and WSA 06.
Originated in Australia as part of AS K138-1963 and AS A160-1969.
Originated in New Zealand in part as NZS 7641:1978, NZS 7642:1971 and NZS 7649:1988.
Previous edition AS/NZS 1260:2002.
Fourth edition 2009.
Reissued incorporating Amendment No. 1 (April 2011).
Reissued incorporating Amendment No. 2 (December 2013).
| AS/NZS 1462.11:1996 | Methods of test for PVC pipes and fittings Method for high temperature stress-relief testing of fittings (Reconfirmed 2017) |
| AS 2887-1993 | Plastic waste fittings |
| HB 18.28-2005 | Conformity assessment - Guidance on a third-party certification system for products |
| AS/NZS 1477:2006 | PVC pipes and fittings for pressure applications |
| AS/NZS 1462.13:2006 | Methods of test for plastics pipes and fittings Method for the determination of elastomeric seal joint contact width and pressure (Reconfirmed 2017) |
| AS/NZS 1462.23:2006 | Methods of test for plastics pipes and fittings Method for determination of ring flexibility (Reconfirmed 2024) |
| AS 2700-1996 | Colour Standards for general purposes - Swatches |
| AS 1199.1-2003 | Sampling procedures for inspection by attributes Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection (Reconfirmed 2016) |
| AS/NZS 1462.1:2006 | Methods of test for plastics pipes and fittings Method for determining the dimensions of pipes and fittings (Reconfirmed 2024) |
| AS/NZS 1462.15:1996 | Methods of test for PVC pipes and fittings Method for determination of vinyl chloride monomer content (Reconfirmed 2017) |
| AS/NZS 1462.16:2006 | Methods of test for plastics pipes and fittings Method for high temperature testing of pipe (Reconfirmed 2017) |
| AS 1172.1-2005 | Water closets (WC) Pans |
| AS 1646-2007 | Elastomeric seals for waterworks purposes (Reconfirmed 2018) |
| AS/NZS 2566.1:1998 | Buried flexible pipelines Structural design |
| AS/NZS 3879:2006 | Solvent cements and priming fluids for PVC (PVC-U and PVC-M) and ABS pipes and fittings |
| AS/NZS 2566.2:2002 | Buried flexible pipelines Installation (Reconfirmed 2016) |
| AS 681.1-2008 | Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications Vulcanized rubber |
| AS 1199.2-2003 | Sampling procedures for inspection by attributes Sampling plans indexed by limiting quality (LQ) for isolated lot inspection (Reconfirmed 2016) |
| AS/NZS 1462.3:1998 | Methods of test for plastics pipes and fittings Method for determining the impact characteristics of pipes (Reconfirmed 2017) |
| AS 1199.0-2003 | Sampling procedures for inspection by attributes Introduction to the ISO 2859 attribute sampling system (Reconfirmed 2016) |
| AS/NZS 1462.5:2002 | Methods of test for plastics pipes and fittings Vicat softening temperature (Reconfirmed 2017) |
| AS/NZS 3500.2:2003 | Plumbing and drainage Sanitary plumbing and drainage |
| AS 1199.3-2003 | Sampling procedures for inspection by attributes Skip-lot sampling procedures (Reconfirmed 2016) |
| AS/NZS 1462.2:2006 | Methods of test for plastics pipes and fittings Method for determining the flattening properties of plastics pipes and fittings |
| AS/NZS 4765:2007 | Modified PVC (PVC-M) pipes for pressure applications |
| AS/NZS 3500.0:2003 | Plumbing and drainage Glossary of terms |
| AS/NZS 1462.22:1997 | Methods of test for plastics pipes and fittings Method for determination of pipe stiffness |
| AS 1199.4-2003 | Sampling procedures for inspection by attributes Procedures for assessment of declared quality levels (Reconfirmed 2016) |
| AS 681.2-2008 | Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications Thermoplastic elastomers |
| AS/NZS 2032:2006 | Installation of PVC pipe systems (Reconfirmed 2024) |
| AS/NZS 1462.8:2008 | Methods of test for plastics pipes and fittings Method of testing the leaktightness of assemblies (Reconfirmed 2017) |
| AS/NZS 1462.4:2002 | Methods of test for plastics pipes and fittings Method for determining reversion of plastics pipes (Reconfirmed 2017) |
| AS/NZS 3500.5:2000 | Plumbing and Drainage Domestic installations |
| AS/NZS 3500.4:2015 | Plumbing and drainage Heated water services |
| AS/NZS 1254:2010 | PVC-U pipes and fittings for stormwater and surface water applications (Reconfirmed 2024) |
| AS/NZS 3500.5:2012 | Plumbing and drainage Housing installations |
| AS/NZS 3879:2011 | Solvent cements and priming fluids for PVC (PVC-U and PVC-M) and ABS and ASA pipes and fittings |
| ATS 5200.501-2011 | Technical Specification for plumbing and drainage products Anti-infiltration overflow-relief device |
| AS/NZS 5601.1:2013 | Gas installations General installations |
| AS/NZS 5601.1:2010 | Gas installations General installations |
| AS/NZS 3500.3:2015 | Plumbing and drainage Stormwater drainage |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.