AS 2136-1977
Current
The latest, up-to-date edition.
Method for detecting the susceptibility of copper and its alloys to stress corrosion cracking using the mercurous nitrate test (Reconfirmed 2018)
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
12-31-1977
Specifies requirements for the testing reagent and describes two methods of preparation of the reagent. Preparation of test pieces, procedures for carrying out the test and details for the preparation of a test report are given.
Committee |
MT/8
|
DocumentType |
Standard
|
ISBN |
0 7262 1389 6
|
Pages |
3
|
ProductNote |
Reconfirmed 1986 Reconfirmed 14/09/2018.
This standard has been reconfirmed in Australia in 2018 and remains current in New Zealand. Reconfirmation Notice 14/09/2018 |
PublisherName |
Standards Australia
|
Status |
Current
|
Supersedes |
This standard describes a procedure for detecting the susceptibility of copper and copper base alloy products to stress corrosion cracking by immersion of test pieces in an acidified solution of mercurous nitrate.NOTES:1. The method is not recommended for the testing of assemblies and partial assemblies but such tests are not precluded by agreement.2. Elapsed time following removal of the test piece from the test solution and subsequent examination should be specified in the product specification.3. Chemical reagents specified in this standard are highly toxic and should be handled with care. The use of rubber gloves is advisable to prevent contact with the skin.4. Mercury and mercury vapour are definite health hazards; equipment for their detection is recommended.5. Volatilization of mercury should only be carried out in a well-ventilated exhaust booth.
First published 1977
AS/NZS 2658:2022 | LP Gas - Portable and mobile appliances |
AS 4621:2019 | Regulator for use with liquefied petroleum - Vapour phase |
ATS 5200.016-2010 | Technical Specification for plumbing and drainage products Cistern inlet valves |
AS 3517-2007 | Capillary fittings of copper and copper alloy for non-pressure sanitary plumbing applications (Reconfirmed 2018) |
AS 4632-2005 | Over-pressure and under-pressure cut off devices |
ATS 5200.004-2005 | Technical Specification for plumbing and drainage products Urinal flushing cisterns |
AS 4620-2004 | Thermoelectric flame safeguards (Reconfirmed 2021) |
AS 4618-2004 | Gas appliance regulators |
AS 1357.1-2004 | Valves primarily for use in heated water systems Protection valves |
ATS 5200.042-2004 | Technical Specification for plumbing and drainage products - Roll-grooved jointing systems |
AS 4617:2018 | Manually operated gas valves |
AS/NZS 2845.1:2010 | Water supply - Backflow prevention devices Materials, design and performance requirements |
AS 5200.037.2-2008 | Plumbing and drainage products Flow controllers for use with heated or cold water systems (Reconfirmed 2016) |
AS 3795-1996 | Copper alloy tubes for plumbing and drainage applications |
AS/NZS 3499:2006 | Water supply - Flexible hose assemblies (Reconfirmed 2016) |
ATS 5200.020-2004 | Technical Specification for plumbing and drainage products Flushing valves for water closets and urinals - for use with mains supply |
AS 4631-2005 | Limited flexibility connectors for gas |
AS 4630-2005 | Leakage detection systems |
AS 5830.1-2012 | In-line ball valves for use in plumbing water supply systems Metal-bodied |
AS 3517-1995 | Capillary fittings of copper and copper alloy for non-pressure sanitary plumbing applications |
ATS 5200.468-2005 | Technical Specification for plumbing and drainage products Hot water systems - Recirculation valves |
AS 4628-2005 | Pressure and temperature limit devices for use with gas burners (Reconfirmed 2018) |
ATS 5200.017-2005 | Technical Specification for plumbing and drainage products Cistern outlet valves |
AS 1718-1992 | Water supply - Copper alloy screw-down pattern taps - Specified by dimensions |
ATS 5200.464-2004 | Technical Specification for plumbing and drainage products - Hot water manual or sensor-activated pumping systems |
AS 4032.2-2005 | Water supply - Valves for the control of hot water supply temperatures Tempering valves and end-of-line temperature-actuated devices (Reconfirmed 2015) |
AS 4631:2018 | Semi-rigid connectors for gas |
AS 3718-1992 | Water supply - Metal-bodied taps - Specified by performance |
ATS 5200.425-2009 | Technical Specification for plumbing and drainage products Water closet (WC) suite with integral odour control device (OCD) connected to sanitary plumbing and drainage system |
ATS 5200.476-2006 | Technical Specification for plumbing and drainage products Heated water systems - Leak protection device |
AS 4621-2004 | Regulators for use with liquefied petroleum - Vapour phase |
AS 1357.2-2005 | Valves primarily for use in heated water systems Control valves (Reconfirmed 2015) |
AS 2658-2003 | LP Gas - Portable and mobile appliances |
AS 1628-1999 | Water supply - Metallic gate, globe and non-return valves (Reconfirmed 2015) |
AS 2658-2008 | LP Gas - Portable and mobile appliances |
ATS 5200.420-2005 | Technical Specification for plumbing and drainage products Trap-priming valves |
AS/NZS 1567:1997 | Copper and copper alloys - Wrought rods, bars and sections (Reconfirmed 2021) |
ATS 5200.477-2006 | Technical Specification for plumbing and drainage products Rainwater/mains supply changeover devices |
ATS 5200.007-2004 | Technical Specification for plumbing and drainage products - Water hammer arrestors |
ATS 5200.489-2009 | Technical Specification for plumbing and drainage products Stainless steel flexible assemblies for plumbing applications |
AS 1572-1998 | Copper and copper alloys - Seamless tubes for engineering purposes (Reconfirmed 2018) |
ATS 5200.037.1-2006 | |
AS 1628-1994 | Water supply - Copper alloy gate, globe and non-return valves |
AS 1569-1998 | Copper and copper alloys - Seamless tubes for heat exchangers (Reconfirmed 2020) |
AS 1910-1994 | Water supply - Float control valves for use in hot and cold water |
AS 4041-1992 | Pressure piping |
AS/NZS 3718:2005 | Water supply - Tap ware (Reconfirmed 2016) |
AS 4618:2019 | Gas appliance regulators |
ATS 5200.021-2004 | Technical Specification for plumbing and drainage products Flushing valves for water closets and urinals - for use with break tank supply |
ATS 5200.467-2004 | Technical Specification for plumbing and drainage products Rainwater tank connection valve |
ATS 5200.482-2006 | Technical Specification for plumbing and drainage products Soil waste dump fitting |
ATS 5200.466-2004 | Technical Specification for plumbing and drainage products - Rainwater tank connection devices |
AS 2712-1993 | Solar water heaters - Design and construction |
ATS 5200.472-2006 | Technical Specification for plumbing and drainage products Heated water system recirculation device |
AS 4619-2004 | Gas appliance thermostats (Reconfirmed 2021) |
AS 4627:2017 | Quick-connect devices for gas |
AS/NZS 3718:2003 | Water supply - Tap ware |
AS 1910-2004 | Water supply - Float control valves for use in hot and cold water (Reconfirmed 2016) |
AS 4032.4:2014 | Water supply - Valves for the control of heated water supply temperatures Thermostatically controlled taps for the control of heated water supply temperatures |
ATS 5200.012-2005 | Technical Specification for plumbing and drainage products In-line valves for use in plumbing water supply systems - Miscellaneous types metallic and non-metallic |
ATS 5200.016-2005 | Technical Specification for plumbing and drainage products - Cistern inlet valves |
AS 4629-2005 | Automatic shut off valves and vent valves (Reconfirmed 2018) |
AS 4627-2005 | Quick-connect devices for gas |
ATS 5200.475-2006 | Technical Specification for plumbing and drainage products Heated Water Systems - Cold water recovery device |
AS 4617-2004 | Manual shut off gas valves |
AS 1357.1-2009 | Valves primarily for use in heated water systems Protection valves |
ATS 5200.481-2006 | Technical Specification for plumbing and drainage products Thermal switching valves |
AS 5200.007-2008 | Plumbing and drainage products Metal-bodied water hammer arresters |
AS 4632:2020 | Over-pressure and under-pressure shut-off devices |
AS/NZS 2712:2002 | Solar and heat pump water heaters - Design and construction |
ATS 5200.052-2005 | Metallic-bodied inlet pressure control valves greater than DN 50 |
AS/NZS 3718:1997 | Water supply - Metal-bodied taps - Specified by performance |
ATS 5200.479-2006 | Flood stop safety valve |
AS 1589-1994 | Copper and copper alloy waste fittings |
ATS 5200.030-2004 | Technical Specification for plumbing and drainage products - Solenoid valves |
AS 3688-2005 | Water supply - Metallic fittings and end connectors |
AS 1589-2001 | Copper and copper alloy waste fittings (Reconfirmed 2018) |
ATS 5200.030-2007 | Technical Specification for plumbing and drainage products Solenoid valves |
ATS 5200.485-2006 | Pressure compensating tank |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.