AS 1141.71-1998

1 - AS 1141.71-1998 METHODS FOR SAMPLING AND TESTING AGGREGATES - LIME OR CEMENT CONTENT OF STABILIZED PAVEMENT MATERIALS (EDTA METH
1 - 1 SCOPE
1 - 2 PRINCIPLE
1 - 3 REFERENCED DOCUMENTS
2 - 4 APPARATUS
2 - 5 REAGENTS
2 - 5.1 General
2 - 5.2 Reagents
3 - 6 SAMPLES
3 - 7 TEST PORTIONS
3 - 7.1 Stabilized material
3 - 7.2 Unstabilized material
3 - 7.3 Stabilizing agent
3 - 8 PROCEDURE
3 - 8.1 Preparation of solutions of test portions
3 - 8.1.1 General
4 - 8.1.2 Lime content determination
4 - 8.1.3 Cement content determination
4 - 8.1.4 Precipitation of mixed trivalent oxides
4 - 8.2 Titration
5 - 9 CALCULATIONS
5 - 9.1 Calcium
5 - 9.2 Lime/cement
6 - 10 TEST REPORT

This Standard sets out the method for determining the lime or cement content of samples of soils, gravel or crushed rock stabilized with lime or cement either in a cured or uncured state by titrating with ethylenediaminetetra-acetic acid disodium salt (EDTA) to determine the soluble calcium ion content (Ca2+).

This Standard sets out the method for determining the lime or cement content of samples of soils, gravel or crushed rock stabilized with lime or cement either in a cured or uncured state by titrating with ethylenediaminetetra-acetic acid disodium salt (EDTA) to determine the soluble calcium ion content (Ca2+).The method is dependent on determining the amount of calcium ions in the stabilized material, the lime or cement additive and the unstabilized material on a dry basis.NOTE: With certain clay minerals present in the matrix, low results may be observed. In such cases, more accurate results may be obtained by using a standard addition technique, that is, standards prepared from known masses of lime and pavement material. These techniques are not described in this Standard and the number of this Standard is not applicable if a standard addition technique is used.

First published as AS 1141.71-1998.