12/30264410 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 199 - ROLLING BEARINGS - THRUST BEARINGS - TOLERANCES
Hardcopy , PDF
07-31-2014
English
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Limit deviations and tolerance values
Annex A (Informative) - Symbols and descriptions of
traditional terms in relationship with new terms
Annex B (Informative) - Example of drawing indications
of characteristics with specification for thrust
bearings
Annex C (informative) - Illustration of ISO 1132-1 and
ISO 14405-1 definitions
Annex D (Informative) - Description with illustrations for
specification modifiers of linear sizes
Bibliography
BS ISO 199
| Committee |
MCE/7
|
| DocumentType |
Draft
|
| Pages |
34
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 8015:2011 | Geometrical product specifications (GPS) Fundamentals Concepts, principles and rules |
| ISO 104:2015 | Rolling bearings Thrust bearings Boundary dimensions, general plan |
| ISO 1132-2:2001 | Rolling bearings Tolerances Part 2: Measuring and gauging principles and methods |
| ISO/TS 17863:2013 | Geometrical product specification (GPS) Tolerancing of moveable assemblies |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO 5593:1997 | Rolling bearings Vocabulary |
| ISO 14253-1:2017 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications |
| ISO 14405-2:2011 | Geometrical product specifications (GPS) Dimensional tolerancing Part 2: Dimensions other than linear sizes |
| ISO 582:1995 | Rolling bearings — Chamfer dimensions — Maximum values |
| ISO 1132-1:2000 | Rolling bearings — Tolerances — Part 1: Terms and definitions |
| ISO 14660-2:1999 | Geometrical Product Specifications (GPS) Geometrical features Part 2: Extracted median line of a cylinder and a cone, extracted median surface, local size of an extracted feature |
| ISO 15241:2012 | Rolling bearings — Symbols for physical quantities |
| ISO 14660-1:1999 | Geometrical Product Specifications (GPS) Geometrical features Part 1: General terms and definitions |
| ISO 14405-1:2016 | Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes |
| ISO 14253-2:2011 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.