I.S. EN 60335-1:2012

National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirement
5 General conditions for the tests
6 Classification
7 Marking and instructions
8 Protection against access to live parts
9 Starting of motor-operated appliances
10 Power input and current
11 Heating
12 Void
13 Leakage current and electric strength at operating
   temperature
14 Transient overvoltages
15 Moisture resistance
16 Leakage current and electric strength
17 Overload protection of transformers and associated
   circuits
18 Endurance
19 Abnormal operation
20 Stability and mechanical hazards
21 Mechanical strength
22 Construction
23 Internal wiring
24 Components
25 Supply connection and external flexible cords
26 Terminals for external conductors
27 Provision for earthing
28 Screws and connections
29 Clearances, creepage distances and solid insulation
30 Resistance to heat and fire
31 Resistance to rusting
32 Radiation, toxicity and similar hazards
Annex A (informative) - Routine tests
Annex B (normative) - Appliances powered by rechargeable
        batteries
Annex C (normative) - Ageing test on motors
Annex D (normative) - Thermal motor protectors
Annex E (normative) - Needle flame test
Annex F (normative) - Capacitors
Annex G (normative) - Safety isolating transformers
Annex H (normative) - Switches
Annex I (normative) - Motors having basic insulation
        that is inadequate for the rated voltage of the
        appliance
Annex J (normative) - Coated printed circuit board
Annex K (normative) - Over-voltage categories
Annex L (informative) - Guidance for the measurement of
        clearances and creepage distances
Annex M (normative) - Pollution degree
Annex N (normative) - Proof tracking test
Annex O (informative) - Selection and sequence of the tests
        of Clause 30
Annex P (informative) - Guidance for the application of this
        standard to appliances used in warm damp equable
        climates
Annex Q (informative) - Sequence of tests for the evaluation
        of electronic circuits
Annex R (normative) - Software evaluation
Annex ZA (normative) - Special national conditions
Annex ZB (informative) - A-deviations
Annex ZC (normative) - Normative references to international
         publications with their corresponding European
         publications
Annex ZD (informative) - IEC and CENELEC code designations
         for flexible cords
Annex ZE (informative) - Specific additional requirements for
         appliances and machines intended for commercial use
Annex ZF (informative) - Criteria applied for the allocation of
         products covered by standards in the EN 60335 series
         under LVD or MD
Annex ZG (normative) - UV appliances
Annex ZZA (informative) - Relationship between this European
          standard and the safety objectives of Directive
          2014/35/EU [2014 OJ L96] aimed to be covered
Annex ZZB (informative) - Relationship between this European
          standard and the essential requirements of Directive
          2006/42/EC aimed to be covered
Bibliography
Index of defined words

Describes the safety of electrical appliances for household and similar purposes, their rated voltage being not more than 250 V for single-phase appliances and 480 V for other appliances.