EN ISO 15252-1:1999

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Designation system
5 Examples of designations
Annex ZA (normative) Normative references to international
         publications with their relevant European publications

1.1 This part of ISO 15252 establishes a data block system for the designation of epoxy powder mouldingcompounds (EP-PMCs).1.2 The various types of EP-PMC are differentiated from each other by a classification system based oninformation about the filler/reinforcement type and content, the intended method of processing, any specialproperties and those of the special properties used specifically for designation purposes (designatory properties).1.3 This part of ISO 15252 is applicable to all EP-PMCs ready for normal use in the form of powder, granules orground material.1.4 It is not intended to imply that materials having the same designation necessarily give the sameperformance. This part of ISO 15252 does not provide engineering data, performance data or data on processingconditions which may be required to specify a material for a particular application and/or method of processing. Ifsuch additional properties are required, they shall be determined in accordance with the test methods specified inpart 2 of this International Standard, if suitable.1.5 Whenever general requirement data, as covered by part 3 of this International Standard, need to beindicated, this is also done using this data block system.1.6 To ensure that code-letters and code-numbers remain unambiguous, and to avoid conflicts within thesystem, any new code-letters or code-numbers for use in data block 1, 2 or 3 shall be approved before use by thesecretariats of ISO/TC 61/SC 1, SC 12 and SC 13.