EN 1870-3:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
6 Information for use
Annex A (normative) - Dimensional tolerances of
        saw spindles
Annex B (normative) - Riving knife mounting strength test
Annex C (normative) - Riving knife lateral stability test
Annex D (normative) - Braking tests
Annex E (normative) - Impact test method for guards
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU Directive
         2006/42/EC
Bibliography

This European Standard deals with all significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to down cutting cross-cut saws and dual purpose down cutting cross-cut saws/circular saw benches, herein after referred to as "machines", designed to cut solid wood, chipboard, fibreboard, plywood and also these materials where they are covered with plastic edging and/or plastic/light alloy laminates when they are used as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse.NOTE 1For the definition of down cutting cross-cut saws and dual purpose down cutting cross -cut saws/circular saw benches, see 3.2.2, 3.2.3 and 3.2.4, and for the definition of displaceable machine, see 3.2.8.This document does not apply to:-machines for cross cutting logs;-hand-held motor-operated electric tools or any adaptation permitting their use in a different mode, i.e. bench mounting;NOTE 2Hand-held motor-operated electric tools and saw benches to form an integrated whole with a hand-held motor-operated electric tools are covered by EN 60745-1:2009 together with EN 60745-2-5:2010.-transportable machines set up on a bench or a table similar to a bench, which are intended to carry out work in a stationary position, capable of being lifted by one person by hand i.e. maximum mass ≤ 25 kg.NOTE 3Transportable motor-operated electric tools are covered by the requirements of EN 61029-1:2009 together with EN 61029-2-9:2009 and EN 61029-2-11:2009.This document is not applicable to down cutting cross-cut saws and dual purpose down cutting cross-cut saws/circular saw benches which are manufactured before the date of its publication as European Standard.