BS EN 13063-2:2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Shapes, dimensions and tolerances
5 Material requirements
6 Replacement of single components of the system
   chimney
7 Designation
8 Product information
9 Marking and labelling
10 Evaluation of conformity
Annex A (normative) Test methods
Annex B (informative) Thermal resistance
Annex C (normative) Sampling procedures for an AQL of 10%
                       and inspection level S2
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of the
                       EU Construction Products Directive
Bibliography

Describes the requirements and test methods for multiwall system chimneys working under wet conditions (in the following expressed as "wet chimney") with pressure type N1, N2 or P1 according to EN 1443 and a working temperature below or equal T600 according to EN 13063-1:2005+A1, in which the products of combustion are conveyed to the atmosphere through clay/ceramic flue liners.

This European Standard specifies the requirements and test methods for multiwall system chimneys working under wet conditions (in the following expressed as \'wet chimney\') with pressure type N1, N2 or P1 according to EN 1443 and a working temperature below or equal T600 according to prEN 13063-1, in which the products of combustion are conveyed to the atmosphere through clay/ceramic flue liners. Marking and inspection are also covered by this document. This European Standard does not apply to structurally independent (free standing or self-supporting) system chimneys. The wet chimney may comprise the following appropriate components: clay/ceramic flue liners; insulation layer; outer walls; acid resistant mortar for jointing flue liners or elastomeric sealant; mortar for jointing outer walls; terminal; chimney base; condensate collector; condensate outlet; cladding; opening section; cleaning and inspection door; distance piece; reinforcement. The wet system chimney covers a combination of compatible chimney components, obtained or specified from one manufacturing source with product responsibility for the whole system chimney. NOTE This document does not cover soot fire resistance chimneys.