ASTM B 947 : 2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Hot Rolling Mill Solution Heat Treatment for Aluminum Alloy Plate
Hardcopy , PDF
10-10-2020
English
01-12-2014
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
B 07
|
| DocumentType |
Standard Practice
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This practice establishes the controls required for hot rolling mill solution heat treatment of the 6xxx series aluminum alloy plate in Table 1 when ASTM material specifications allow use of this process instead of furnace solution heat treatment. For the alloys listed in Table 1, this practice is an alternate process to solution heat treatment in a furnace, such as specified in Practice B918 as the preliminary step for the attainment of T651-type tempers (see ANSI H35.1/H35.1M).
1.2This practice applies only to hot rolling mill solution heat treatment of plate for the listed aluminum alloys. Precipitation hardening (aging), processing, and equipment calibration for aging shall meet the practice and requirements of Practice B918.
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 2281 : 2015 | Standard Practice for Process Capability and Performance Measurement |
| ASTM E 2281 : 2003 | Standard Practice for Process and Measurement Capability Indices |
| ASTM E 2281 : 2008 | Standard Practice for Process and Measurement Capability Indices |
| ASTM E 2281 : 2008 : REV A | Standard Practice for Process and Measurement Capability Indices |
| ASTM E 2281 : 2008 : REV A : R2012 : EDT 1 | Standard Practice for Process and Measurement Capability Indices |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.