11/30199264 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 13106 - PLASTICS - BLOW-MOULDED POLYPROPYLENE CONTAINERS FOR PACKAGING OF LIQUID FOODSTUFFS
Hardcopy , PDF
31-05-2014
English
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Capacity
5 Container mass - tare weight
6 Raw material
7 Tolerance on dimensions
8 Requirement
9 Marking
10 Sampling & criterion for conformity
Annex A (normative) - NECK HEIGHT DETERMINATION
Annex B (normative) - NECK FINISH DIMENSIONS
Bibliography
BS ISO 13106.
| Committee |
PRI/75
|
| DocumentType |
Draft
|
| Pages |
17
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS 1918-2:1981 | Glass container finishes Specification for crown finish |
| ISO 15270:2008 | Plastics — Guidelines for the recovery and recycling of plastics waste |
| ISO 22088-1:2006 | Plastics — Determination of resistance to environmental stress cracking (ESC) — Part 1: General guidance |
| ISO 1873-2:2007 | Plastics Polypropylene (PP) moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties |
| BS 1918-1:1978 | Glass container finishes Specification for continuous thread finish |
| BIS IS 10909 : 2001(R2015) | POSITIVE LIST OF CONSTITUENTS OF POLYPROPYLENE AND ITS COPOLYMERS IN CONTACT WITH FOODSTUFFS, PHARMACEUTICALS AND DRINKING WATER |
| ISO 1873-1:1995 | Plastics Polypropylene (PP) moulding and extrusion materials Part 1: Designation system and basis for specifications |
| ISO 11469:2016 | Plastics — Generic identification and marking of plastics products |
| ASTM D 2659 : 2016 : REDLINE | Standard Test Method for Column Crush Properties of Blown Thermoplastic Containers |
| BS 4839-1:1972 | Plastics containers Containers up to 5 litres capacity |
| BIS IS 10910 : 1984(R1997) | SPECIFICATION FOR POLYPROPYLENE AND ITS COPOLYMERS FOR ITS SAFE USE IN CONTACT WITH FOODSTUFFS, PHARMACEUTICALS AND DRINKING WATER |
| BIS IS 2798 : 1998 AMD 2 2009 | METHODS OF TEST FOR PLASTICS CONTAINERS |
| ISO 9113:1986 | Plastics Polypropylene (PP) and propylene-copolymer thermoplastics Determination of isotactic index |
| ASTM D 5857 : 2017 : REDLINE | Standard Specification for Polypropylene Injection and Extrusion Materials Using ISO Protocol and Methodology |
| BIS IS 10951 : 2002 | POLYPROPYLENE MATERIALS FOR MOULDING AND EXTRUSION |
| ISO 1043-1:2011 | Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics |
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Logging out.