EN 13985:2003+A1:2009

Foreword
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
  3.1 Terms and definitions
  3.2 Abbreviations
4 List of significant hazards
5 Safety requirements and/or protective measures
  5.1 General
  5.2 Basic design considerations
  5.3 Mechanical hazards in the blade and associated
      area
  5.4 The control and monitoring system
  5.5 Tool-setting, trial strokes, maintenance and
      lubrication
  5.6 Mechanical hazards - Other
  5.7 Slips, trips and falls
  5.8 Protection against other hazards
6 Verification of the safety requirements and/or
  protective measures
7 Information for use
  7.1 Marking
  7.2 Instruction handbook
Annex A (normative) Calculation of minimum safety
         distances
Annex B (normative) The response time of the redundant
         hydraulic/pneumatic systems
Annex C (informative) Example of a hydraulic control
         circuit for a guillotine shear provided with
         fixed guards or light curtain
Annex D (normative) Conditions for noise measurement of
         guillotine shears
Annex ZA (informative) Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC, amended by Directive 98/79/EC
Annex ZB (informative) Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

1.1This European Standard specifies technical safety requirements and measures to be adopted by persons undertaking the design as defined in 3.11 of EN 292-1:1991, manufacture and supply of guillotine shears which are intended to work cold metal or material partly of cold metal as defined in 3.1.7 and hereafter referred as machines.1.2This standard also covers guillotine shears whose primary intended use is to work cold metal, which are to be used in the same way to work other sheet materials (e.g. cardboard, plastic, rubber, leather).1.3The requirements in this standard take account of intended use, as defined in 3.12 of EN 292-1:1991. This standard presumes access to the guillotine shear from all directions, deals with the hazards described in clause 4, and specifies the safety requirements and/or protective measures for both the operator and other exposed persons.1.4This standard also applies to ancillary devices which are an integral part of the guillotine shear. This standard also applies to machines which are integrated into an automatic production line where the hazards and risk arising are comparable to those of machines working separately.1.5This standard includes guillotine shears in which energy is imparted to the blade by a number of means. e.g.:a)mechanically driven from a motor through a friction clutch;b)through a direct drive motor and brake;c)through hydraulic pressure;d)through pneumatic pressure.1.6This standard does not cover machines whose principal designed purpose is:a)cutting in other than a straight line (e.g. at nibbling machines);b)cutting by continuous action at crocodile shears (see 3.4).1.7This standard does not cover the safety requirements related to the use of PES or PPS. They will be dealt with at its next revision.1.8This standard is not applicable to machines which are manufactured before the date of publication of this document by CEN.