ASTM E 126 : 2019
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Inspection, Calibration, and Verification of ASTM Hydrometers
Hardcopy , PDF
06-03-2024
English
05-01-2019
Important note : All end users must be registered with an Account prior to user licenses being assigned.
This test method describes the principles, apparatus, and procedures for the inspection, calibration, and verification of ASTM glass hydrometers.
| Committee |
E 20
|
| DocumentType |
Test Method
|
| Pages |
9
|
| ProductNote |
THIS STANDARD ALSO REFERS TO ANSI/NCSLI
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method describes the principles, apparatus, and procedures for the inspection, calibration, and verification of ASTM glass hydrometers. This test method is applicable to ASTM hydrometers and may be used for other general hydrometers of the constant-mass, variable-displacement type.
1.2The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. The metric equivalents of inch-pound units may be approximate.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 50 : 2017 | Standard Practices for Apparatus, Reagents, and Safety Considerations for Chemical Analysis of Metals, Ores, and Related Materials |
| ASTM D 287 : 2022 | Standard Test Method for API Gravity of Crude Petroleum and Petroleum Products (Hydrometer/Method) |
| ASTM D 6466 : 2010 : R2018 | Standard Test Method for Diameter of Wool and Other Animal Fibers By Sirolan-Laserscan Fiber Diameter Analyser |
| ASTM D 7928 : 2021 : EDT 1 | Standard Test Method for Particle-Size Distribution (Gradation) of Fine-Grained Soils Using the Sedimentation (Hydrometer) Analysis |
| ASTM D 4371/D4371M : 2006 : R2019 : EDT 1 | Standard Test Method for Determining the Washability Characteristics of Coal |
| ASTM D 1566 : 2021 : REV A | Standard Terminology Relating to Rubber |
| ASTM E 344 : 2020 | Terminology Relating to Thermometry and Hydrometry |
| ASTM D 1657 : 1989 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Thermohydrometer (Withdrawn 1998) |
| ASTM D 1265 : 1997 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 1298 : 2012 : REV A | Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM D 1657 : 2022 : EDT 1 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM E 344 : 2023 | Terminology Relating to Thermometry and Hydrometry |
| ASTM D 1657 : 2002 : R2007 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM E 100 : 1995 : R2001 | Standard Specification for ASTM Hydrometers |
| ASTM D 1298 : 2012 : REV B | Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM D 1657 : 2022 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM E 344 : 2018 | Terminology Relating to Thermometry and Hydrometry |
| ASTM D 1298 : 2012 : REV B : R2017 : EDT 1 | Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM E 2251 : 2007 | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM E 344 : 2001 : REV A | Terminology Relating to Thermometry and Hydrometry |
| ASTM E 100 : 2019 : R2024 | Standard Specification for ASTM Hydrometers |
| ASTM D 1265 : 2023 : REV A | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM E 2251 : 2003 : REV A | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM D 1298 : 1999 : R2005 | Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM D 1298 : 2012 : REV B : R2017 | Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM D 1298 : 2012 | Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM D 1298 : 1999 : EDT 2 | Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM E 2995 : 2015 : REV A | Standard Specification for ASTM Thermohydrometers with Integral Low-Hazard Thermometers |
| ASTM E 2251 : 2003 | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM E 2251 : 2014 : R2021 | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM D 1298 : 1999 | Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM E 77 : 2014 : EDT 1 | Standard Test Method for Inspection and Verification of Thermometers |
| ASTM E 2251 : 2010 | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM E 2251 : 2011 | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM E 2251 : 2014 | Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids |
| ASTM E 2995 : 2014 | Standard Specification for ASTM Thermohydrometers with Integral Low-Hazard Thermometers |
| ASTM D 1298 : 1999 : EDT 1 | Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM E 2995 : 2015 | Standard Specification for ASTM Thermohydrometers with Integral Low-Hazard Thermometers |
| ASTM D 1657 : 2012 : R2017 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM D 1265 : 2004 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM E 100 : 2019 | Standard Specification for ASTM Hydrometers |
| ASTM D 1265 : 2011 : R2017 : EDT 1 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM E 1 : 2014 : R2020 | Standard Specification for ASTM Liquid-in-Glass Thermometers |
| ASTM D 1265 : 2005 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 1265 : 2004 : REV A | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 1265 : 2011 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM D 1298 : 1985 : R1990 : EDT 1 | Standard Practice for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method |
| ASTM D 1265 : 2023 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM D 1657 : 2012 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM D 1657 : 2012 : EDT 1 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM D 1265 : 2022 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM E 77 : 1998 | Standard Test Method for Inspection and Verification of Thermometers |
| ASTM D 1657 : 2002 | Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer |
| ASTM E 77 : 2014 : R2021 | Standard Test Method for Inspection and Verification of Thermometers |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.