AS/NZS 3003:2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Electrical installations - Patient areas
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
07-30-2024
04-01-2011
Important note : All end users must be registered with an Account prior to user licenses being assigned.Sets out requirements for new electrical installations and for alterations, additions and repairs of existing electrical installations in patient areas.
| Committee |
HT-021
|
| DocumentType |
Standard
|
| ISBN |
978 0 7337 9804
|
| Pages |
79
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This Standard sets out requirements for new electrical installations and for alterations, additions and repairs of existing electrical installations in patient areas. Areas other than patient areas are not covered by this Standard, but are covered by the relevant requirements of AS/NZS 3000.This Standard nominates specific maximum values of electromagnetic interference. This matter needs careful consideration at the design stage. In some patient areas, these values need to be measured.This Standard specifies the patient area classification for certain locations.NOTES:1 Where a patient area is not listed in this Standard, refer to AS/NZS 2500 for guidance. AS/NZS 2500 outlines the procedure for determining where cardiac-protected electrical areas are required. These decisions are made by the governing body or proprietor of the health care facility, based on the classification of the medical procedures undertaken in each area and the protection against electric shock provided in the medical electrical equipment available for these procedures. 2 Requirements for mobile trolleys supporting electrical equipment are given in AS/NZS 3551.3 Requirements for emergency lighting are given in AS/NZS 2293.1. 4 Requirements for emergency power systems in hospitals are given in AS/NZS 3009. 5 In New Zealand, mobile medical connectable installations must comply with the requirements of this Standard and NZS 6115.
Originated in Australia as part of AS 3003 1976.
Originated in New Zealand as AS/NZS 3003:1999.
Previous edition 2003.
Fifth edition 2011.
| AS/NZS 2500:2004 | Guide to the safe use of electricity in patient care |
| AS/NZS 60320.1:2004 | Appliance couplers for household and similar general purposes General requirements (IEC 60320-1, Ed. 2.0 (2001) MOD) |
| UNI EN ISO 9170-1 : 2008 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM |
| AS 3011.2-1992 | Electrical installations - Secondary batteries installed in buildings Sealed cells |
| AS/NZS 3009:1998 | Electrical installations - Emergency power supplies in hospitals |
| AS/NZS 4510:1999 | Isolated electrical supply systems for medical use (Reconfirmed 2016) |
| AS/NZS 3200.1.0-1998 | Medical electrical equipment General requirements for safety - Parent Standard |
| AS 3011.1-1992 | Electrical installations - Secondary batteries installed in buildings - Vented cells Vented cells |
| AS/NZS 3000:2007 | Electrical installations (known as the Australian/New Zealand Wiring Rules) |
| AS/NZS 3008.1.1:2009 | Electrical installations - Selection of cables Cables for alternating voltages up to and including 0.6/1 kV - Typical Australian installation conditions |
| AS 2293.1-2005 | Emergency escape lighting and exit signs for buildings System design, installation and operation |
| AS/NZS 61009.1:2004 | Residual current operated circuit breakers with integral overcurrent protection for household and similar uses (RCBOs) General rules (IEC 61009-1, Ed. 2.1 (2003) MOD) |
| AS/NZS 3190:2009 | Approval and test specification - Residual current devices (current-operated earth-leakage devices) |
| AS/NZS 61008.1:2004 | Residual current operated circuit breakers without integral overcurrent protection for household and similar uses (RCCBs) General rules (IEC 61008-1, Ed. 2.1 (2002) MOD) |
| AS/NZS 3008.1.2:2010 | Electrical installations - Selection of cables Cables for alternating voltages up to and including 0.6/1 kV - Typical New Zealand conditions |
| AS/NZS 3551:2004 | Technical management programs for medical devices |
| AS/NZS 60898.1:2004 | Electrical accessories - Circuit-breakers for overcurrent protection for household and similar installations Circuit-breakers for a.c. operation (IEC 60898-1, Ed. 1.2 (2003) MOD) |
| AS/NZS 3123:2005 | Approval and test specification - Plugs, socket-outlets and couplers for general industrial application (Reconfirmed 2016) |
| I.S. EN ISO 9170-1:2008 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM |
| ISO 9170-1:2017 | Terminal units for medical gas pipeline systems — Part 1: Terminal units for use with compressed medical gases and vacuum |
| UNI EN ISO 9170-2 : 2008 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS |
| AS 1319-1994 | Safety signs for the occupational environment (Reconfirmed 2018) |
| BS EN ISO 9170-2:2008 | Terminal units for medical gas pipeline systems Terminal units for anaesthetic gas scavenging systems |
| EN ISO 9170-1:2008 | Terminal units for medical gas pipeline systems - Part 1: Terminal units for use with compressed medical gases and vacuum (ISO 9170-1:2008) |
| AS/NZS 3111:2009 | Approval and test specification - Miniature overcurrent circuit-breakers (Reconfirmed 2020) |
| AS/NZS 3100:2009 | |
| AS/NZS 3120:1999 | Approval and test specification - Cord extension sockets |
| DIN EN ISO 9170-1:2016-09 (Draft) | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM |
| I.S. EN ISO 9170-2:2008 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS |
| ISO 9170-2:2008 | Terminal units for medical gas pipeline systems — Part 2: Terminal units for anaesthetic gas scavenging systems |
| EN ISO 9170-2:2008 | Terminal units for medical gas pipeline systems - Part 2: Terminal units for anaesthetic gas scavenging systems (ISO 9170-2:2008) |
| 16/30314880 DC : 0 | BS EN ISO 9170-1 - TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM |
| DIN EN ISO 9170-2:2009-09 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS |
| BS EN ISO 9170-1:2008 | Terminal units for medical gas pipeline systems Terminal units for use with compressed medical gases and vacuum |
| AS/NZS 1125:2001 | Conductors in insulated electric cables and flexible cords (Reconfirmed 2017) |
| AS/NZS 3112:2004 | Approval and test specification - Plugs and socket-outlets |
| AS/NZS 5000.1:2005 | Electric cables - Polymeric insulated For working voltages up to and including 0.6/1 (1.2) kV (Reconfirmed 2017) |
| CSA Z9170.1 : 2011 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES, VACUUM, AND ANAESTHETIC GAS SCAVENGING SYSTEMS |
| CSA Z9170.1 : 2011 : R2015 | TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES, VACUUM, AND ANAESTHETIC GAS SCAVENGING SYSTEMS |
| AS/NZS 5762:2011 | In-service safety inspection and testing - Repaired electrical equipment |
| AS/NZS 3190:2016 | Approval and test specification - Residual current devices (current operated earth-leakage devices) |
| AS/NZS 3190:2016 | Approval and test specification - Residual current devices (current operated earth-leakage devices) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.