UNI EN 1360 : 2013

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Materials and construction
6 Pressure requirements
7 Dimensions and tolerances
8 Physical properties
9 End fittings
10 Type tests
11 Frequency of testing
12 Marking
Annex A (normative) - Test method for determination
        of low temperature resistance at -30 degrees C
        (for normal temperature class) and -40 degrees C
        (for low temperature class)
Annex B (normative) - Method for the determination
        of adhesion between components
Annex C (normative) - Test method for the determination
        of low temperature flexibility
Annex D (normative) - Test method for the determination
        of fuel permeation
Annex E (normative) - Test method for flammability
Annex F (normative) - End-fitting pull-off test
Annex G (normative) - Test method for the determination
        of leakage (leak test)
Annex H (normative) - Test method for fatigue strength
        under reversed bending stress (flex test)
Annex I (normative) - Test frequency for type tests and
        routine tests
Annex J (informative) - Test frequency for production
        acceptance tests
Bibliography

Defines minimum requirements and test methods for verification for three types of hoses in two grades and two classes of hose assemblies used for measured fuel dispensing, including oxygenated fuels (up to a maximum of 15 % oxygenated compounds).