UNI EN 1013-1 : 1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
LIGHT TRANSMITTING PROFILED PLASTIC SHEETING FOR SINGLE SKIN ROOFING - GENERAL REQUIREMENTS AND TEST METHODS
09-05-2022
01-01-1999
Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
4 Symbols and abbreviations
5 Requirements
6 Test methods
7 Ageing procedure and measurement after ageing
(type test)
8 Marking, labelling, packaging
Annex A (normative) Profile terminology
Defines the general requirements for profile plastic translucent sheets for single skin roofing whatever material is used to produce the sheets. Defines test procedures, either as a type test or quality control test, excepting that for dimensional tolerances. The test procedure for dimensional tolerances is included for provision of a common approach for the purchaser and manufacturer in the event of dispute over measurements. Applies to all kinds of translucent roofing sheets, used in any type of building.
DocumentType |
Standard
|
PublisherName |
Ente Nazionale Italiano di Unificazione (UNI)
|
Status |
Superseded
|
SupersededBy |
Standards | Relationship |
SN EN 1013-1 : 1997 | Identical |
UNE-EN 1013-1:1998 | Identical |
NEN EN 1013-1 : 1998 | Identical |
I.S. EN 1013-1:1998 | Identical |
NF EN 1013-1 : 1998 | Identical |
EN 1013-1:1997 | Identical |
DIN EN 1013-1:1998-01 | Identical |
NBN EN 1013-1 : 1998 | Identical |
BS EN 1013-1:1998 | Identical |
NS EN 1013-1 : 1ED 1998 | Identical |
UNI 11418-2 : 2011 | DISCONTINUOUS ROOFING - REQUIREMENTS FOR ROOFER QUALIFICATION - PART 2: GUIDES AND INSTRUCTIONS FOR THE INSTALLATION |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.