SN EN 60282-1 : 2006

1 General
  1.1 Scope
  1.2 Normative references
2 Normal and special service conditions
  2.1 Normal service conditions
  2.2 Special service conditions
  2.3 Environmental behaviour
3 Definitions
  3.1 Electrical characteristics
  3.2 Fuses and their component parts
  3.3 Additional terms
4 Ratings and characteristics
  4.1 Rated voltage
  4.2 Rated insulation level (of a fuse-base)
  4.3 Rated frequency
  4.4 Rated current of the fuse-base
  4.5 Rated current of the fuse-link
  4.6 Temperature-rise limits
  4.7 Rated breaking capacity
  4.8 Limits of switching voltage
  4.9 Rated transient recovery voltage (rated TRV)
  4.10 Maximum application temperature of full-range fuses
  4.12 Cut-off characteristics
  4.13 l[2]t characteristics
  4.14 Mechanical characteristics of strikers
  4.15 Special requirement for back-up fuses intended for use in
       switch-fuse combination according to IEC 60420
5 Design, construction and performance
  5.1 General requirements with respect to fuse operation
  5.2 Identifying markings
  5.3 Dimensions
6 Type tests
  6.1 Conditions for making the tests
  6.2 List of type tests
  6.3 Common test practices for all type tests
  6.4 Dielectric tests
  6.5 Temperature-rise tests and power-dissipation measurement
  6.6 Breaking tests
  6.7 Tests for time-current characteristics
  6.8 Oil-tightness tests
  6.9 Tests of strikers
  6.10 Electromagnetic compatibility (EMC)
7 Special tests
  7.1 List of special tests
8 Application guide
  8.1 Object
  8.2 General
  8.3 Application
  8.4 Operation
  8.5 Disposal
Annex A (normative) Method of drawing the envelope of the prospective
        and transient recovery voltage of a circuit and determining
        the representative parameters
Annex B (informative) Reasons which led to the choice of TRV values
        for Test Duties 1, 2 and 3
Annex C (informative) Preferred arrangements for temperature-rise
        tests of oil-tight fuse-links for switchgear
Annex D (informative) Types and dimensions of current-limiting
        fuse-links specified in existing national standards
Annex E (normative) Method of determining the minimum test current
        l[3] of a full-range fuse intended for use at surrounding
        temperature above 40 degree C
Annex F (informative) Determination of derating when the temperature
        surrounding the fuse exceeds 40 degree C
Annex ZA (normative) Normative references to international publications
         with their corresponding European publications
Bibliography
  

Applies to all types of high-voltage current-limiting fuses designed for use outdoors or indoors on alternating current systems of 50 Hz and 60 Hz and of rated voltages exceeding 1000 V.