SN EN 1301-1 : 2008

Foreword
1 Scope
2 Normative references
3 Definitions
    3.1 Wire
    3.2 Cast
    3.3 Manufacturing batch
    3.4 Inspection lot
    3.5 Heat-treatment batch or lot
    3.6 Sample
    3.7 Specimen
    3.8 Test piece
    3.9 Test
4 Orders or tenders
5 Requirements
    5.1 Production and manufacturing processes
    5.2 Quality control
    5.3 Chemical composition
    5.4 Mechanical properties
    5.5 Freedom from defects
    5.6 Tolerances on dimensions
    5.7 Other properties
6 Test procedure
    6.1 Sampling
    6.2 Methods of test
    6.3 Retests
7 Inspection documents
    7.1 General
    7.2 Documents established on the basis of inspections
          and tests performed by qualified personnel
          who are involved in the manufacturing process
          and/or belong to the quality control department
    7.3 Documents established on the basis of inspections
          and tests performed or supervised by qualified
          personnel organizationally independent from the
          manufacturing department, according to the
          requirements specified on the order and carried
          out on the products for delivery or on the
          relevant inspection lot
8 Marking
9 Packing
10 Arbitration
Annex A (informative) Bibliography
 

Defines technical conditions for inspecting and delivering aluminium and aluminium alloy drawn wire for general engineering purposes, including rivet manufacture (not including aeronautical rivets). Applicable to drawn wire excepting electrical or welding applications, but does not apply to drawing stock.