SAE ARP4296A
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
View Superseded by
Drawing Interpretation and Standard Machining Practices, Couplings, Fittings and Hose Ends, Fluid Systems
Hardcopy , PDF
29-03-2019
English
07-10-2014
Important note : All end users must be registered with an Account prior to user licenses being assigned.
1. SCOPE
2. APPLICABLE DOCUMENTS
3. REQUIREMENTS
4. NOTES
Proposes to interpret and clarify engineering drawing requirements relating to the manufacture and inspection of fluid system couplings, tube fittings, and hose ends.
| DocumentType |
Standard
|
| Pages |
7
|
| PublisherName |
SAE International
|
| Status |
Withdrawn
|
| SupersededBy | |
| Supersedes |
This SAE Aerospace Recommended Practice (ARP) is intended to interpret and clarify engineering drawing requirements relating to the manufacture and inspection of fluid system couplings, tube fittings, and hose ends. Because it is impractical to define every minute detail of the part on the face of the drawing, this document describes interpretations of dimensioning of general machining features and otherwise undefined tolerances that fall under the heading of \"good shop practice\". This document serves as a supplement to engineering drawings when referenced on applicable documents.
| SAE AS85421/11D | FITTING, UNION, BEAM SEAL, 3000/4000 PSI, MALE ENDS |
| SAE AS21905E | TEE, FLARELESS TUBE |
| SAE AS21911E | TEE, BULKHEAD, FLARELESS TUBE, INTERNAL THREAD ON RUN |
| SAE AS85421/8B | FITTING, CROSS, REDUCER BEAM SEAL, 3000/4000 PSI, FOUR MALE ENDS |
| SAE AS21904E | ELBOW, FLARELESS TUBE, 90 DEGREES |
| SAE AS4971A | FITTING, ELBOW, 90°, WELD RING |
| SAE AS932C | FITTING, ADAPTER, REDUCER/EXPANDER, FLARELESS TO BOSS |
| SAE AS21925E | ELBOW, 90° UNIVERSAL, FLARELESS TUBE, HIGH PROFILE |
| SAE AS4408C | FITTING ASSEMBLY, ELBOW 90°, REDUCER AND NONREDUCER, INTERNAL FLARE |
| PREN 4834 : DRAFT 2017 | AEROSPACE SERIES - ADAPTOR, PIPE COUPLING 24 DEGREES CONE UP TO 35000 KPA (5080 PSI) PORT FOR RING LOCKED FITTING - INCH SERIES - GEOMETRIC CONFIGURATION |
| SAE AS5169C | FITTING, PORT PLUG AND BLEEDER |
| SAE AS85421/5D | FITTING, TEE, REDUCER AND NON-REDUCER, BEAM SEAL, 3000/4000 PSI, MALE ON RUN AND BRANCH, SWIVEL NUT ON RUN |
| SAE AS4409C | FITTING ASSEMBLY, ELBOW 45°, REDUCER AND NONREDUCER, INTERNAL FLARE TO FLARED TUBE |
| SAE ARP4266 | Hole Contour, Fluid Passage, Tube Fitting |
| SAE ARP4784A | Definitions and Limits, Metal Material Defects and Surface and Edge Features, Fluid Couplings, Fittings and Hose Ends |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.