PREN 81-21 : DRAFT 2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATION OF LIFTS - LIFTS FOR THE TRANSPORT OF PERSONS AND GOODS - PART 21: NEW PASSENGER AND GOODS PASSENGER LIFTS IN EXISTING BUILIDING
01-09-2009
12-01-2013
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective measures
5.1 Perforate wall of the lift well
5.2 Clearances between car, counterweight or
balancing weight
5.3 Counterweight or balancing weight in a
separate well
5.4 Pulleys in the well
5.5 Reduced top clearances
5.6 Car roof balustrade
5.7 Reduced bottom clearances
5.8 Apron
5.9 Height of machine room
5.10 Height of machine room doors
5.11 Dimensions of trap doors for machine room
5.12 Height of pulley rooms
5.13 Dimensions of trap doors for pulley room
5.14 Height of landing doors
6 Verification of safety requirements and/or protective
measures
6.1 Verification table
6.2 Tests before putting the lift into service
6.3 Technical dossier
7 Information for use
7.1 Instructions
7.2 Notices and warnings
Annex A (normative) - List of the electric safety devices
Annex B (informative) - Periodical examinations and tests,
examinations and tests after an important
modification or after an accident
B.1 Periodical examinations and tests
B.2 Examinations and tests after an important modification
or after an accident
Annex C (normative) - Examination of pre-triggered stopping
system
C.1 General provisions
C.2 Statement and test samples
C.3 Laboratory tests
C.3.1 Method of test
C.3.2 Determination of the nominal braking force
of the stopping gear
C.3.3 Checking after the tests
C.4 Calculation
C.4.1 Calculation method
C.4.2 Site test case
C.4.3 Worst cases
Annex ZA (informative) - Relationship between this European
Standard and the Essential Requirements of EU
Directive 95/16/EC
Bibliography
Describes the safety rules related to new passenger- and goods/passenger lifts permanently installed in existing buildings where in some circumstances due to limitations enforced by building constraints.
| Committee |
TC 10
|
| DocumentType |
Draft
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| Standards | Relationship |
| NF EN 81-21 : 2009 + A1 2012 | Identical |
| 16/30332867 DC : 0 | Identical |
| 09/30173298 DC : 0 | Identical |
| EN 81-80:2003 | Safety rules for the construction and installation of lifts - Existing lifts - Part 80: Rules for the improvement of safety of existing passenger and goods passenger lifts |
| UNI EN 81-80 : 2009 | SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATION OF LIFTS - EXISTING LIFTS - PART 80: RULES FOR THE IMPROVEMENT OF SAFETY OF EXISTING PASSENGER AND GOODS PASSENGER LIFTS |
| BS EN 81-80:2003 | Safety rules for the construction and installation of lifts. Existing lifts Rules for the improvement of safety of existing passenger and goods passenger lifts |
| DIN EN 81-70:2005-09 | SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATION OF LIFTS - PARTICULAR APPLICATIONS FOR PASSENGER AND GOODS PASSENGERS LIFTS - PART 70: ACCESSIBILITY TO LIFTS FOR PERSONS INCLUDING PERSONS WITH DISABILITY |
| VDI 2510 Blatt 3:2017-09 | Automated guided vehicle systems (AGVS) - Interfaces to infrastructure and peripherals |
| DIN EN 81-70:2015-11 (Draft) | SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATIONS OF LIFTS - PARTICULAR APPLICATIONS FOR PASSENGER AND GOODS PASSENGERS LIFTS - PART 70: ACCESSIBILITY TO LIFTS FOR PERSONS INCLUDING PERSONS WITH DISABILITY |
| DIN EN 81-80:2004-02 | SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATION OF LIFTS - EXISTING LIFTS - PART 80: RULES FOR THE IMPROVEMENT OF SAFETY OF EXISTING PASSENGER AND GOODS PASSENGER LIFTS |
| I.S. EN 81-80:2004 | SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATION OF LIFTS - EXISTING LIFTS - RULES FOR THE IMPROVEMENT OF SAFETY OF EXISTING PASSENGER AND GOODS PASSENGER LIFTS |
| BS EN 81-70:2003 | Safety rules for the construction and installation of lifts Particular applications for passenger and goods passenger lifts. Accessibility to lifts for persons including persons with disability |
| EN ISO 14121-1:2007 | Safety of machinery - Risk assessment - Part 1: Principles (ISO 14121-1:2007) |
| EN 81-1:1998+A3:2009 | Safety rules for the construction and installation of lifts - Part 1: Electric lifts |
| EN ISO 13857:2008 | Safety of machinery - Safety distances to prevent hazard zones being reached by upper and lower limbs (ISO 13857:2008) |
| ISO 14121-1:2007 | Safety of machinery Risk assessment Part 1: Principles |
| 1995/16/EC : 1995 | DIRECTIVE 95/16/EC OF 29 JUNE 1995 ON THE APPROXIMATION OF THE LAWS OF THE MEMBER STATES RELATING TO LIFTS |
| EN 81-2 : 1998 + A3 2009 | SAFETY RULES FOR THE CONSTRUCTION AND INSTALLATION OF LIFTS - PART 2: HYDRAULIC LIFTS |
| ISO 12100-2:2003 | Safety of machinery Basic concepts, general principles for design Part 2: Technical principles |
| ISO 13857:2008 | Safety of machinery Safety distances to prevent hazard zones being reached by upper and lower limbs |
| ISO 3864-1:2011 | Graphical symbols Safety colours and safety signs Part 1: Design principles for safety signs and safety markings |
| ISO 12100-1:2003 | Safety of machinery Basic concepts, general principles for design Part 1: Basic terminology, methodology |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.