PD CEN/TS 1455-2:2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviated terms
5 General
6 Testing and inspection
Annex A (informative) - Basic test matrix
Bibliography

Provides guidance for the assessment of conformity of materials (compounds/formulations), products and assemblies in accordance with EN 1455-1 intended to be included in the manufacturer's quality plan as part of the quality management system and for the establishment of third-party certification procedures.

This Technical Specification gives guidance for the assessment of conformity of materials (compounds/formulations), products and assemblies in accordance with EN 1455-1 intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of third-party certification procedures.

NOTE 1 It is recommended that the quality management system conforms to or is no less stringent than the relevant requirements to EN ISO 9001 [1].

NOTE 2 If third-party certification is involved, it is recommended that the certification body is accredited to EN 45011 [2], EN 45012 [3] or EN ISO/IEC 17021 [4], as applicable.

NOTE 3 In order to help the reader, a basic test matrix is given in Annex A.

In conjunction with EN 1455-1, this document is applicable to solid-wall piping systems made of acrylonitrile-butadiene-styrene (ABS) intended to be used for the following purposes:

• for soil and waste discharge (low and high temperature) inside buildings (application area code \'B\');

• for soil and waste discharge (low and high temperature) inside buildings and buried in ground within the building structure (application area code \'BD\').

NOTE 4 This is reflected in the marking of products by \'B\' or \'BD\'.