NBN EN 10130 : 2007

Foreword
1 Scope
2 Normative references
3 Definitions
4 Designation
5 Requirements
5.1 Steelmaking and manufacturing processes
5.2 Deoxidation
5.3 Chemical composition
5.4 Delivery condition
5.5 Choice of properties
5.6 Mechanical properties
5.7 Surface characteristics
      5.7.1 General
      5.7.2 Surface quality
      5.7.3 Surface finish
5.8 Stretcher strain marks
      5.8.1 General
      5.8.2 Skin-passed products
      5.8.3 Non-skin-passed products
5.9 Suitability for surface coating
5.10 Weldability
5.11 Tolerances on shape and dimensions
6 Tests
6.1 General
6.2 Inspection units
6.3 Number of tests
6.4 Sampling
6.5 Test methods
6.6 Retests
6.7 Inspection documents
7 Marking
8 Packing
9 Disputes
10 Information to be supplied by the purchaser at the
      time of enquiry and order
Annexes
A Method of determination of the plastic strain
      ratio r
B Method of determination of the strain hardening
      exponent n
C List of national standards corresponding to
      referenced EURONORMS
D List of grades
E Bibliography

Pertains to cold rolled uncoated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm and, unless otherwise agreed at the time of inquiry and order, equal to or less than 3 mm, delivered in sheet, coil, slit coil, or cut lengths obtained from slit coil or sheet.