I.S. EN ISO 13297:2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SMALL CRAFT - ELECTRICAL SYSTEMS - ALTERNATING CURRENT INSTALLATIONS (ISO 13297:2014)
Hardcopy , PDF
05-11-2018
English
01-01-2014
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Marking
6 Ignition sources
7 Overcurrent protection
8 Ground-fault protection/earth-leakage protection
9 Appliances and equipment
10 System wiring
11 Conductor and cable installation
12 Panel boards (switchboards)
13 Socket outlets
14 Power source options
15 Inverters and inverter/chargers
Annex A (normative) - Conductor requirements
Annex B (normative) - Instructions to be included
with owner's manual
Annex C (informative) - Recommended system tests
Annex D (informative) - Typical a.c. system diagrams
Bibliography
Annex ZA (informative) - Relationship between this
European Standard and the Essential
Requirements of EU Directive 94/25/EC as
amended by Directive 2003/44/EC
Describes the requirements for the design, construction and installation of low-voltage alternating current electrical systems which operate at nominal voltages of less than 250 V single phase on small craft of hull length up to 24 m.
DocumentType |
Standard
|
Pages |
40
|
PublisherName |
National Standards Authority of Ireland
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
Standards | Relationship |
ONORM EN ISO 13297 : 2015 | Identical |
UNI EN ISO 13297 : 2015 | Identical |
BS EN ISO 13297:2014 | Identical |
ISO 13297:2014 | Identical |
DIN EN ISO 13297:2015-04 | Identical |
NF EN ISO 13297 : 2015 | Identical |
NS EN ISO 13297 : 2014 | Identical |
NBN EN ISO 13297 : 2015 | Identical |
UNE-EN ISO 13297:2015 | Identical |
SN EN ISO 13297 : 2015 | Identical |
NEN EN ISO 13297 : 2014 | Identical |
EN ISO 13297:2014 | Identical |
ISO 10239:2014 | Small craft Liquefied petroleum gas (LPG) systems |
ISO 7010:2011 | Graphical symbols Safety colours and safety signs Registered safety signs |
ISO 10088:2013 | Small craft — Permanently installed fuel systems |
ISO 8820-1:2014 | Road vehicles Fuse-links Part 1: Definitions and general test requirements |
ISO 9097:1991 | Small craft Electric fans |
ISO 11105:1997 | Small craft Ventilation of petrol engine and/or petrol tank compartments |
IEC 61543:1995 | Residual current-operated protective devices (RCDs) for household and similar use - Electromagnetic compatibility |
IEC 60947-7-1:2009 | Low-voltage switchgear and controlgear - Part 7-1: Ancillary equipment - Terminal blocks for copper conductors |
IEC 61009-1:2010+AMD1:2012+AMD2:2013 CSV | Residual current operated circuit-breakers with integral overcurrentprotection for household and similar uses (RCBOs) - Part 1: General rules |
ISO 10133:2012 | Small craft Electrical systems Extra-low-voltage d.c. installations |
IEC 60364-7-709:2007+AMD1:2012 CSV | Low-voltage electrical installations - Part 7-709: Requirements for special installations or locations - Marinas and similar locations |
IEC 60529:1989+AMD1:1999+AMD2:2013 CSV | Degrees of protection provided by enclosures (IP Code) |
ISO 8846:1990 | Small craft — Electrical devices — Protection against ignition of surrounding flammable gases |
ISO 8849:2003 | Small craft Electrically operated direct-current bilge pumps |
ISO 10134:2003 | Small craft Electrical devices Lightning-protection systems |
IEC 60079-0:2011 | Explosive atmospheres - Part 0: Equipment - General requirements |
IEC 60898-2:2016 | Electrical accessories - Circuit-breakers for overcurrent protection for household and similar installations - Part 2: Circuit-breakers for AC and DC operation |
ISO 10240:2004 | Small craft Owner's manual |
IEC 60309-2:1999+AMD1:2005+AMD2:2012 CSV | Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories |
ISO 3864-4:2011 | Graphical symbols Safety colours and safety signs Part 4: Colorimetric and photometric properties of safety sign materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.