I.S. EN 62811:2015
Current
The latest, up-to-date edition.
AC AND/OR DC-SUPPLIED ELECTRONIC CONTROLGEAR FOR DISCHARGE LAMPS (EXCLUDING FLUORESCENT LAMPS) - PERFORMANCE REQUIREMENTS FOR LOW FREQUENCY SQUAREWAVE OPERATION
Hardcopy , PDF
English
01-01-2015
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General notes on tests
5 Marking
6 General statement
7 Starting conditions
8 Operating conditions
9 Displacement factor
10 Supply current
11 Endurance
Annex A (normative) - Tests
Annex B (normative) - Reference ballasts
Annex C (normative) - Conditions for reference lamps
Annex D (normative) Control interface for controllable
Controlgear
Annex E (normative) - Spectral analysis of power ripple:
calculation procedure for amplitude spectrum
ratio and guidance
Annex F (normative) - Open circuit voltage method of
measurement for pulse ignition
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Describes performance requirements for electronic controlgear for use on a.c. and/or d.c. supplies up to 1000 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz, associated with discharge lamps, as specified in IEC 61167, which have information for low frequency square wave operation, where the frequency range of the low frequency is from 70 Hz to 400 Hz.
| DevelopmentNote |
For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
|
| DocumentType |
Standard
|
| Pages |
80
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Standards | Relationship |
| EN 62811:2015 | Identical |
| IEC 61547:2009 | Equipment for general lighting purposes - EMC immunity requirements |
| IEC 61347-1:2015 RLV | Lamp controlgear - Part 1: General and safety requirements |
| EN 61000-4-14:1999/A2:2009 | ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 4-14: TESTING AND MEASUREMENT TECHNIQUES - VOLTAGE FLUCTUATION IMMUNITY TEST FOR EQUIPMENT WITH INPUT CURRENT NOT EXCEEDING 16 A PER PHASE |
| IEC 61167:2015 | Metal halide lamps - Performance specification |
| IEC 60410:1973 | Sampling plans and procedures for inspection by attributes |
| EN 61347-1:2015 | Lamp controlgear - Part 1: General and safety requirements |
| IEC 61347-2-12:2005+AMD1:2010 CSV | Lamp controlgear - Part 2-12: Particular requirements for d.c. or a.c. supplied electronic ballasts for discharge lamps (excluding fluorescent lamps) |
| IEC 61000-4-14:1999+AMD1:2001+AMD2:2009 CSV | Electromagnetic compatibility (EMC) - Part 4-14: Testing and measurement techniques - Voltage fluctuation immunity test for equipment with input current not exceeding 16 A per phase |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.