I.S. EN 1366-3:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test equipment
5 Test conditions
   5.1 Heating conditions
   5.2 Pressure conditions
6 Test specimen
   6.1 Size and distances
   6.2 Number
   6.3 Design
   6.4 Construction
   6.5 Verification
7 Installation of test specimen
   7.1 General
   7.2 Supporting construction
   7.3 Installation of service(s)
   7.4 Installation of penetration seal
   7.5 Multiple penetration seals in one test specimen
8 Conditioning
9 Application of instrumentation
   9.1 Thermocouples
   9.2 Integrity measurement
   9.3 Pressure
10 Test procedure
   10.1 General
   10.2 Integrity
   10.3 Other observations
11 Performance criteria
   11.1 Integrity
   11.2 Insulation
   11.3 Multiple penetrations
12 Test report
13 Field of direct application of test results
   13.1 Orientation
   13.2 Supporting construction
   13.3 Services
   13.4 Service support construction
   13.5 Seal size and distances
Annex A (normative) - Standard configuration for large cable
        penetration seals
        A.1 Structure of specimens
        A.2 Non-standard configuration
        A.3 Field of direct application
Annex B (normative) - Standard configuration for small cable
        penetration seals
        B.1 Structure of specimens
        B.2 Field of direct application
        B.3 Non-standard configuration
Annex C (normative) - Standard configuration and field of direct
        application for modular systems and cable boxes
        C.1 Modular Systems
        C.2 Cable boxes
        C.3 Non-standard configuration
Annex D (normative) - Specimen design and field of direct
        application for bus bars
        D.1 Structure of specimens
        D.2 Field of direct application
        D.3 Non-standard configuration
Annex E (normative) - Standard configuration and field of direct
        application for pipe penetration seals
        E.1 Standard configuration for penetration seals for
            pipes according to 6.3.2 a) - "metal pipes"
        E.2 Standard configuration for penetration seals for
            pipes according to 6.3.2 d) - "plastic pipes"
        E.3 Trunking and conduits
        E.4 Standard configuration for floor penetrations ending
            at floor level (e.g. floor drain)
Annex F (normative) - Standard configuration and field of direct
        application for large mixed penetration seals
        F.1 General
        F.2 Standard Mixed Module
        F.3 Standard configuration for combinations of
            type a) according to F.1.2
        F.4 Standard configuration for combinations of
            type b), c) and d) according to F.1.2
        F.5 Field of direct application
Annex G (normative) - Critical pipe/cable approach
        G.1 General
        G.2 Definition of "critical"
        G.3 Procedure selecting critical pipes from previous
            test data
        G.4 Procedure selecting critical cables from previous
            test data
Annex H (informative) - Explanatory notes
        H.1 General
        H.2 Notes on the scope and application of test results
        H.3 Notes on test conditions
        H.4 Notes on test construction
        H.5 Notes on test procedure
        H.6 Notes on test criteria
        H.7 Notes on validity of test results (field of
            application)
        H.8 Notes on test report
Bibliography

Describes a method of test and criteria for the evaluation (including field of application rules) of the ability of a penetration seal to maintain the fire resistance of a separating element at the position at which it has been penetrated by a service.