I.S. EN 1071-13:2010
Current
The latest, up-to-date edition.
ADVANCED TECHNICAL CERAMICS - METHODS OF TEST FOR CERAMIC COATINGS - PART 13: DETERMINATION OF WEAR RATE BY THE PIN-ON-DISK METHOD
Hardcopy , PDF
English
01-01-2010
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Principle
6 Apparatus
7 Preparation of test pieces
8 Testing procedure
9 Repeatability and limits
10 Report
Annex A (informative) - Methods for the determination of
coating properties likely to be relevant to coating
performance in a pin-on-disk wear test
Annex B (informative) - Determination of volume loss from the
pin using profilometry
Annex C (informative) - Determination of wear of coated disk by
ball crater technique
Bibliography
Specifies a method for evaluating the wear of ceramic coatings by use of a test in which a flat or spherically ended pin is brought, under load, into contact with the flat surface of a disk and the two are set in relative motion such that the pin describes a circular path on the disk.
| DocumentType |
Standard
|
| Pages |
25
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Standards | Relationship |
| EN 1071-13:2010 | Identical |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| EN 1071-6:2007 | Advanced technical ceramics - Methods of test for ceramic coatings - Part 6: Determination of the abrasion resistance of coatings by a micro-abrasion wear test |
| DIN 51834-2:2016-03 (Draft) | TESTING OF LUBRICANTS - TRIBOLOGICAL TEST IN THE TRANSLATORY OSCILLATION APPARATUS - PART 2: DETERMINATION OF FRICTION AND WEAR DATA FOR LUBRICATING OILS |
| ISO 14577-4:2016 | Metallic materials Instrumented indentation test for hardness and materials parameters Part 4: Test method for metallic and non-metallic coatings |
| EN 1071-12:2010 | Advanced technical ceramics - Methods of test for ceramic coatings - Part 12: Reciprocating wear test |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| CEN/TS 1071-11:2005 | Advanced technical ceramics - Methods of test for ceramic coatings - Part 11: Determination of internal stress by the Stoney formula |
| ISO 31-0:1992 | Quantities and units Part 0: General principles |
| ASTM G 99 : 2017 : REDLINE | Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus |
| EN ISO 14577-4:2016 | Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 4: Test method for metallic and non-metallic coatings (ISO 14577-4:2016) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.