EN ISO 27108:2013

Foreword
Introduction
1 Scope
2 Normative references
3 Principle
4 Interferences
5 Reagents
6 Apparatus
7 Sampling and sample pretreatment
8 Procedure
9 Calibration
10 Calculation
11 Expression of result
12 Test report
Annex A (informative) - Examples of gas chromatograms for
        compounds listed in Table 1
Annex B (informative) - Mass spectra of compounds of Table
        1 (full-scan, EI, 70 eV)
Annex C (informative) - Precision data
Annex D (informative) - General information about SPME
Bibliography

ISO 27108:2010 specifies a method for the determination of the dissolved amount of selected plant treatment agents and biocide products in drinking water, ground water and surface water by solid‑phase microextraction (SPME) followed by gas chromatography-mass spectrometry (GC‑MS). The limit of determination depends on the matrix, on the specific compound to be analysed and on the sensitivity of the mass spectrometer. For most plant treatment agents and biocides to which ISO 27108:2010 applies, it is at least 0,05 µg/l. Validation data related to a concentration range between 0,05 µg/l and 0,3 µg/l have been demonstrated in an interlaboratory trial.This method may be applicable to other compounds not explicitly covered by ISO 27108:2010 or to other types of water. However, it is necessary to verify the applicability of this method for these special cases.