EN 820-5:2009

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Method A: Static bending method
  4.1 Principle
  4.2 Apparatus
  4.3 Test pieces
  4.4 Procedure
  4.5 Calculation of results
  4.6 Accuracy and interferences
5 Method B: Resonance method
  5.1 Principle
  5.2 Apparatus
  5.3 Test pieces
  5.4 Procedure
  5.5 Calculation of results
  5.6 Accuracy and interferences
6 Method C: Impulse excitation method
  6.1 Principle
  6.2 Apparatus
  6.3 Test pieces
  6.4 Procedure
  6.5 Calculation
  6.6 Accuracy and interferences
7 Test report
  7.1 General
  7.2 Method A
  7.3 Method B
  7.4 Method C
Bibliography

This part of EN 820 describes methods for determining the elastic moduli, specifically Young's modulus, shear modulus and Poisson's ratio, of advanced monolithic technical ceramics at temperatures above room temperature. The standard prescribes three alternative methods for determining some or all of these three parameters:Athe determination of Young's modulus by static flexure of a thin beam in three- or four-point bending.Bthe determination of Young's modulus by forced longitudinal resonance, or Young's modulus, shear modulus and Poisson's ratio by forced flexural and torsional resonance, of a thin beam.Cthe determination of Young's modulus from the fundamental natural frequency of a struck bar (impulse excitation method).This part of EN 820 extends the above-defined room-temperature methods described in EN 843-2 to elevated temperatures. All the test methods assume the use of homogeneous test pieces of linear elastic materials. The test assumes that the test piece has isotropic elastic properties. At high porosity levels all of the methods can become inappropriate. The maximum grain size (see EN 623-3), excluding deliberately added whiskers, should be less than 10 % of the minimum dimension of the test piece.NOTE 1Method C in EN 843-2 based on ultrasonic time of flight measurement has not been incorporated into this part of EN 820. Although the method is feasible to apply, it is specialised, and outside the capabilities of most laboratories. There are also severe restrictions on test piece geometries and methods of achieving pulse transmission. For these reasons this method has not been included in EN 820-5.NOTE 2The upper temperature limit for this test depends on the properties of the test pieces, and can be limited by softening within the timescale of the test. In addition, for method A there can be limits defined by the choice of test jig construction materials.