EN 61319-1:1996/A11:1999
Current
The latest, up-to-date edition.
INTERCONNECTIONS OF SATELLITE RECEIVING EQUIPMENT - PART 1: EUROPE
28-04-1999
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Explanation of terms and abbreviations
4 Interface requirements for polarizers and
polarswitchers
4.1 Mechanical polarizers (optional)
4.2 Magnetic polarizers (using the Faraday effect)
4.2.1 Polarizers for two orthogonal polarizations
4.2.2 Polarizers for four polarizations
4.3 Polarswitchers
5 Interface requirements for low-noise block
converters (LNB)
5.1 Characteristic impedance of the first intermediate
frequency (IF) output
5.2 Interface between the LNB (outdoor part) and the satellite
receiver (indoor part), case 1: one IF input signal and
one two-state control command
5.2.1 Single-band block converters
5.2.2 Dual-band block converters
5.2.3 Combination of dual-band block converter with
polarswitcher
5.3 Interface between the LNB (outdoor part) and the
satellite receiver (indoor part) case 2: two IF
input signals and internal two-state control command
5.4 Connectors
6 Interface requirements for switching between different antenna
sources or antenna positions
6.1 Electrical matching values for the actuator motor supply
6.2 Electrical matching values for the antenna position sensor
6.3 Interface between the antenna position control unit and
the satellite receiver
6.3.1 Circular connector
6.3.2 Domestic Digital Bus (D2B)
7 Interface requirements for satellite receivers and external
decoders, descramblers and conditional access systems
8 Interface requirements for Digital Satellite Radio (DSR)
receivers
8.1 Configuration of receiving equipment
8.1.1 Direct reception of radio only
8.1.2 Direct reception of radio and television
8.1.3 Cable reception
8.2 Audio-frequency outputs of DSR receivers
Annex A (informative) Interconnections between a satellite
receiver and a decoder
Annex ZA (normative) Normative references to international
publications with their corresponding
European publications
Annex ZB (normative) Communication between the satellite
receiver and the peripheral equipment using
the Digital Satellite Equipment Control
bus (DiSEqC)
ZB.1 Scope
ZB.2 Normative references
ZB.3 Basic principle of the extended signalling method
ZB.4 Typical applications
ZB.5 Combination of conventional and new signalling messages
ZB.6 Simple Tone Burst control signal
ZB.7 Method of data bit signalling
ZB.8 Structure of a DiSEqC message
ZB.9 Cascaded DiSEqC devices
ZB.10 Power management
ZB.11 Reset at power set-up
ZB.12 Reset when using loop-through tuners
ZB.13 D.C. voltage rise and settling time
ZB.14 Time sequences for DiSEqC messages
ZB.15 Frequency allocation of the local oscillators
ZB.16 Characteristics of the signalling d.c. voltage
ZB.17 Characteristics of the 22 kHz signalling tone
ZB.18 Transport of the 22 kHz tone
ZB.19 IPR, trademark and logo
Figures
Covers standardization of interconnections and matching values for satellite receivers for individual television and sound radio broadcast reception in the 10,70 GHz to 12,75 GHz band
Committee |
TC 100X
|
DocumentType |
Standard
|
PublisherName |
European Committee for Standards - Electrical
|
Status |
Current
|
Standards | Relationship |
UNE-EN 61319-1:1997 | Identical |
IEC 61319-1:1995 | Identical |
NF EN 61319-1 : 96 AMD 11 1999 | Identical |
NBN EN 61319-1 : 1997 AMD 1 2000 | Identical |
NEN EN IEC 61319-1 : 1996 AMD 11 1999 | Identical |
I.S. EN 61319-1:1999 | Identical |
PN EN 61319-1 : 2000 AMD 11 2003 | Identical |
SN EN 61319-1 : 1996 AMD 11 1999 | Identical |
BS EN 61319-1:1996 | Identical |
CEI EN 61319-1 : 1999 | Identical |
DIN EN 61319-1:1999-11 | Identical |
UNE-EN 61319-1/A11:2000 | Identical |
CEI EN 60728-3 : 2011 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR CABLE NETWORKS |
CEI EN 60728-5 : 2016 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT |
PD CLC/TS 50607:2013 | Satellite signal distribution over a single coaxial cable. Second generation |
CEI EN 50607 : 2015 | SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE - SECOND GENERATION |
BS EN 50201:2001 | Interfaces for DVB-IRD |
I.S. EN 50607:2015 | SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE - SECOND GENERATION |
UNE-EN 60728-3:2012 | Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for cable networks |
EN 50256:1998 | Characteristics of DVB receivers |
EN 50201:2001 | Interfaces for DVB-IRD |
EN 50494:2007 | Satellite signal distribution over a single coaxial cable in single dwelling installations |
06/30150711 DC : 0 | BS EN 50494 - SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE IN SINGLE DWELLING INSTALLATIONS |
I.S. EN 50083-3:2002 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR COAXIAL CABLE NETWORKS |
BS EN 50083-3:1999 | Cabled distribution systems for television and sound signals Active wideband equipment for coaxial cable networks |
CEI EN 50201 : 2002 | INTERFACES FOR DVB-IRD |
I.S. EN 60728-3:2011 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR CABLE NETWORKS |
I.S. EN 50494:2007 | SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE IN SINGLE DWELLING INSTALLATIONS |
BS EN 50494:2007 | Satellite signal distribution over a single coaxial cable in single dwelling installations |
BS EN 60728-5:2008 | Cable networks for television signals, sound signals and interactive services Headend equipment |
S.R. CLC/TS 50607:2013 | SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE - SECOND GENERATION |
I.S. EN 50256:1998 | CHARACTERISTICS OF DVB RECEIVERS |
BS EN 60728-3:2011 | Cable networks for television signals, sound signals and interactive services Active wideband equipment for cable networks |
BS EN 50256:1998 | Characteristics of DVB receivers |
CEI EN 50494 : 2008 | SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE IN SINGLE DWELLING INSTALLATIONS |
I.S. EN 50201:2002 | INTERFACES FOR DVB-IRD |
CEI EN 50256 : 1999 | CHARACTERISTICS OF DVB RECEIVERS |
CLC/TS 50607:2013 | Satellite signal distribution over a single coaxial cable - Second generation |
BS EN 50607:2015 | Satellite signal distribution over a single coaxial cable. Second generation |
I.S. EN IEC 60728-3:2018 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR CABLE NETWORKS (TA 5) |
TR 101 790 : 1.4.1 | DIGITAL VIDEO BROADCASTING (DVB); INTERACTION CHANNEL FOR SATELLITE DISTRIBUTION SYSTEMS; GUIDELINES FOR THE USE OF EN 301 790 |
EN IEC 60728-3:2018 | Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for cable networks (TA 5) |
I.S. EN 60728-5:2016 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT |
EN 303 372-1 : 1.1.1 | SATELLITE EARTH STATIONS AND SYSTEMS (SES); SATELLITE BROADCAST RECEPTION EQUIPMENT; HARMONISED STANDARD COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE DIRECTIVE 2014/53/EU; PART 1: OUTDOOR UNIT RECEIVING IN THE 10,7 GHZ TO 12,75 GHZ FREQUENCY BAND |
EN 50083-3:2002 | Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for coaxial cable networks |
EN 60728-5:2016 | Cable networks for television signals, sound signals and interactive services - Part 5: Headend equipment |
EN 50607:2015 | Satellite signal distribution over a single coaxial cable - Second generation |
EN 61030:1993 | Audio, video and audiovisual systems - Domestic Digital Bus (D2B) |
EN 60065:2014/AC:2017-01 | AUDIO, VIDEO AND SIMILAR ELECTRONIC APPARATUS - SAFETY REQUIREMENTS (IEC 60065:2014/COR2:2016) |
HD 134.2 : 200S2 | RADIO-FREQUENCY CONNECTORS - COAXIAL UNMATCHED CONNECTOR |
IEC 60169-2:1965 | Radio-frequency connectors. Part 2: Coaxial unmatched connector |
IEC 60130-9:2011 | Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment |
HD 483.15 : 200S4 | SOUND SYSTEM EQUIPMENT - PREFERRED MATCHING VALUES FOR THE INTERCONNECTION OF SOUND SYSTEM COMPONENTS |
HD 483.11 : 200S3 | SOUND SYSTEM EQUIPMENT - APPLICATION OF CONNECTORS FOR THE INTERCONNECTION OF SOUND SYSTEM COMPONENTS |
IEC 60933-4:1994 | Audio, video and audiovisual systems - Interconnections and matching values - Part 4: Connector and cordset for domestic digital bus (D2B) |
IEC 60958:1989 | Digital audio interface |
EN 60933-4:1994 | Audio, video and audiovisual systems - Interconnections and matching values - Part 4: Connector and cordset for domestic digital bus (D2B) |
IEC 60268-15:1996 | Sound system equipment - Part 15: Preferred matching values for the interconnection of sound system components. |
EN 60130-9:2011 | Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment |
IEC 61030:1991 | Audio, video and audiovisual systems - Domestic Digital Bus (D2B) |
EN 60169-24:1993 | Radio-frequency connectors - Part 24: Radio-frequency coaxial connectors with screw coupling, typically for use in 75 ohm cable distribution systems (Type F) |
IEC 60169-24:1991 | Radio-frequency connectors - Part 24: Radio-frequency coaxial connectors with screw coupling, typically for use in 75 ohm cable distribution systems (Type F) |
EN 60958:1990/A2:1995 | DIGITAL AUDIO INTERFACE |
IEC 60268-11:1987 | Sound system equipment. Part 11: Application of connectors for the interconnection of sound system components |
IEC 60807-9:1993 | Rectangular connectors for frequencies below 3 MHz - Part 9: Detail specification for a range of peritelevision connectors |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.