• Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

EN 61315:2006

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Calibration of fibre-optic power meters

Superseded date

05-02-2022

Superseded by

EN IEC 61315:2019

Published date

31-01-2006

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Preparation for calibration
  4.1 Organization
  4.2 Traceability
  4.3 Advice for measurements and calibrations
  4.4 Recommendations to customers
5 Absolute power calibration
  5.1 Establishing the calibration conditions
  5.2 Calibration procedure
  5.3 Calibration uncertainty
  5.4 Reporting the results
6 Measurement uncertainty of a calibrated power meter
  6.1 Uncertainty at reference conditions
  6.2 Uncertainty at operating conditions
7 Nonlinearity calibration
  7.1 Nonlinearity calibration based on superposition
  7.2 Nonlinearity calibration based on comparison
      with a calibrated power meter
  7.3 Nonlinearity calibration based on comparison
      with an attenuator
  7.4 Calibration of power meter for high power
      measurement
Annex A (normative) Mathematical basis
Bibliography

This international standard is applicable to instruments measuring radiant power emitted from sources which are typical for the fibre-optic communications industry. The standard describes the calibration of power meters to be performed by calibration laboratories or by power meter manufacturers.

Committee
CLC/SR 86
DocumentType
Standard
PublisherName
European Committee for Standards - Electrical
Status
Superseded
SupersededBy

Standards Relationship
UNE-EN 61315:2006 Identical
NF EN 61315 : 2006 Identical
SN EN 61315 : 2006 Identical
BS EN 61315:2006 Identical
CEI EN 61315 : 2007 Identical
I.S. EN 61315:2006 Identical
NEN EN IEC 61315 : 2006 Identical
IEC 61315:2005 Identical
NBN EN 61315 : 2007 Identical
DIN EN 61315:2006-09 Identical
OVE/ONORM EN 61315 : 2006 Identical
PN EN 61315 : 2006 Identical
PNE-prEN 61315 Identical

BS EN 62150-1:2005 Fibre optic active components and devices. Test and measurement procedures General and guidance
BS EN 61300-1:2016 Fibre optic interconnecting devices and passive components. Basic test and measurement procedures General and guidance
I.S. EN 61280-4-2:2014 FIBRE-OPTIC COMMUNICATION SUBSYSTEM TEST PROCEDURES - PART 4-2: INSTALLED CABLE PLANT - SINGLE-MODE ATTENUATION AND OPTICAL RETURN LOSS MEASUREMENT
EN 61280-4-2:2014 Fibre-optic communication subsystem test procedures - Part 4-2: Installed cable plant - Single-mode attenuation and optical return loss measurement
EN 61280-4-1:2009 Fibre optic communication subsystem test procedures - Part 4-1: Installed cable plant - Multimode attenuation measurement
EN 62007-2:2009 Semiconductor optoelectronic devices for fibre optic system applications - Part 2: Measuring methods
EN 62129-1:2016 Calibration of wavelength/optical frequency measurement instruments - Part 1: Optical spectrum analyzers
EN 62129-2:2011 Calibration of wavelength/optical frequency measurement instruments - Part 2: Michelson interferometer single wavelength meters
CEI EN 62150-1 : 2005 FIBRE OPTIC ACTIVE COMPONENTS AND DEVICES - TEST AND MEASUREMENT PROCEDURES - PART 1: GENERAL AND GUIDANCE
BS EN 62129-1:2016 Calibration of wavelength/optical frequency measurement instruments Optical spectrum analyzers
BS EN 61280-1-1:2013 Fibre optic communication subsystem basic test procedures Test procedures for general communication subsystems. Transmitter output optical power measurement for single-mode optical fibre cable
CEI EN 62129-2 : 2012 CALIBRATION OF WAVELENGTH/OPTICAL FREQUENCY MEASUREMENT INSTRUMENTS - PART 2: MICHELSON INTERFEROMETER SINGLE WAVELENGTH METERS
I.S. EN 62129-2:2011 CALIBRATION OF WAVELENGTH/OPTICAL FREQUENCY MEASUREMENT INSTRUMENTS - PART 2: MICHELSON INTERFEROMETER SINGLE WAVELENGTH METERS
BS EN 61280-4-2:2014 Fibre-optic communication subsystem test procedures Installed cable plant. Single-mode attenuation and optical return loss measurement
CEI EN 61280-4-1 : 2011 FIBRE OPTIC COMMUNICATION SUBSYSTEM TEST PROCEDURES - PART 4-1: INSTALLED CABLE PLANT - MULTIMODE ATTENUATION MEASUREMENT
CEI EN 61280-4-2 : 2015 FIBRE-OPTIC COMMUNICATION SUBSYSTEM TEST PROCEDURES - PART 4-2: INSTALLED CABLE PLANT - SINGLE-MODE ATTENUATION AND OPTICAL RETURN LOSS MEASUREMENT
CEI EN 61280-1-1 : 2014 FIBRE OPTIC COMMUNICATION SUBSYSTEM BASIC TEST PROCEDURES - PART 1-1: TEST PROCEDURES FOR GENERAL COMMUNICATION SUBSYSTEMS - TRANSMITTER OUTPUT OPTICAL POWER MEASUREMENT FOR SINGLE-MODE OPTICAL FIBRE CABLE
I.S. EN 61300-1:2016 FIBRE OPTIC INTERCONNECTING DEVICES AND PASSIVE COMPONENTS - BASIC TEST AND MEASUREMENT PROCEDURES - PART 1: GENERAL AND GUIDANCE
BS EN 62129-2:2011 Calibration of wavelength/optical frequency measurement instruments Michelson interferometer single wavelength meters
BS EN 61280-4-1:2009 Fibre optic communication subsystem test procedures Installed cable plant. Multimode attenuation measurement
BS EN 62150-2:2011 Fibre optic active components and devices. Test and measurement procedures ATM-PON transceivers
BS EN 62522:2014 Calibration of tuneable laser sources
BS EN 62007-2:2009 Semiconductor optoelectronic devices for fibre optic system applications Measuring methods
I.S. EN 61280-4-1:2009 FIBRE OPTIC COMMUNICATION SUBSYSTEM TEST PROCEDURES - PART 4-1: INSTALLED CABLE PLANT - MULTIMODE ATTENUATION MEASUREMENT
I.S. EN 61280-1-1:2013 FIBRE OPTIC COMMUNICATION SUBSYSTEM BASIC TEST PROCEDURES - PART 1-1: TEST PROCEDURES FOR GENERAL COMMUNICATION SUBSYSTEMS - TRANSMITTER OUTPUT OPTICAL POWER MEASUREMENT FOR SINGLEMODE OPTICAL FIBRE CABLE (IEC 61280-1-1:2013 (EQV))
I.S. EN 62150-1:2005 FIBRE OPTIC ACTIVE COMPONENTS AND DEVICES - TEST AND MEASUREMENT PROCEDURES - PART 1: GENERAL AND GUIDANCE
GS QKD 011 : 1.1.1 QUANTUM KEY DISTRIBUTION (QKD); COMPONENT CHARACTERIZATION: CHARACTERIZING OPTICAL COMPONENTS FOR QKD SYSTEMS
UNE-EN 61300-1:2017 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 1: General and guidance
EN 62150-2:2011 Fibre optic active components and devices - Test and measurement procedures - Part 2: ATM-PON transceivers
EN 61300-1:2016 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 1: General and guidance
EN 61280-1-1:2013 Fibre optic communication subsystem basic test procedures - Part 1-1: Test procedures for general communication subsystems - Transmitter output optical power measurement for single-mode optical fibre cable
EN 62150-1:2005 Fibre optic active components and devices - Test and measurement procedures - Part 1: General and guidance
EN 62522:2014 Calibration of tuneable laser sources

ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories
IEC 60825-2:2004+AMD1:2006+AMD2:2010 CSV Safety of laser products - Part 2: Safety of optical fibre communication systems (OFCS)
IEC 60050-731:1991 International Electrotechnical Vocabulary (IEV) - Part 731: Optical fibre communication
IEC 60793-2:2015 Optical fibres - Part 2: Product specifications - General
IEC 60825-1:2014 Safety of laser products - Part 1: Equipment classification and requirements
IEC TR 61930:1998 Fibre optic graphical symbology
IEC TR 61931:1998 Fibre optic - Terminology
IEC 61300-3-12:1997 Fibre optic interconnecting devices and passive components - Basictest and measurement procedures - Part 3-12: Examinations andmeasurements - Polarization dependence of attenuation of asingle-mode fibre optic component: Matrix calculation method
IEC 60359:2001 Electrical and electronic measurement equipment - Expression of performance
IEC 60050-300:2001 International Electrotechnical Vocabulary (IEV) - Part 300: Electrical and electronic measurements and measuring instruments - Part 311: General terms relating to measurements - Part 312: General terms relating to electrical measurements - Part 313: Types of electrical measuring instruments - Part 314: Specific terms according to the type of instrument
IEC 61040:1990 Power and energy measuring detectors, instruments and equipment for laser radiation

Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.