EN 15411:2011
Current
The latest, up-to-date edition.
Solid recovered fuels - Methods for the determination of the content of trace elements (As, Ba, Be, Cd, Co, Cr, Cu, Hg, Mo, Mn, Ni, Pb, Sb, Se, Tl, V and Zn)
07-09-2011
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Safety remarks
5 Principle
6 Apparatus
7 Reagents
8 Procedure
9 Digestion procedure
10 Analysis of the digestion solutions
11 Expression of results
12 Quality control
13 Performance characteristics
14 Test report
Annex A (normative) - Guidelines - Characteristics of the
laboratory sample for chemical analysis of SRF
Annex B (informative) - Performance data
Annex C (informative) - Major results of ruggedness testing
Bibliography
This European Standard specifies three methods of digestion for solid recovered fuels:a) microwave assisted digestion with hydrofluoric, nitric and hydrochloric acid mixture;b) hot water bath digestion of with hydrofluoric, nitric and hydrochloric acid mixture, after ashing of the SRFssample;c) oven digestion with nitric, perchloric and hydrofluoric acid mixture.Instrumental determination of As, Ba, Be, Cd, Cr, Co, Cu, Pb, Mn, Mo, Ni, Sb, Se, Tl, V, Zn is performed byInductively Coupled Plasma with optical or mass detection or graphite furnace Atomic AbsorptionSpectrometry. Hg can be analysed only after the microwave assisted procedure or, alternatively, by a directanalysis method (Hg direct AMA).The effectiveness of the digestion can be verified by qualitative X-ray fluorescence (XRF) analysis on theremaining residue. If necessary, an alternative digestion method (among those proposed) is used.Method a) is recommended for general use, but the amount of the test portion can be very low in case of highconcentration of organic matter.Method b) is recommended for Solid Recovered Fuel (SRF) with high organic matter concentration that canbe difficult to digest with the other methods. This method is not suitable for mercury.Method c) is recommended for Solid Recovered Fuel (SRF) samples for which the other methods leave asignificant insoluble residue.Alternative digestion methods can be applied if their performance is proved to be comparable with those of themethods mentioned in a) to c) (see Annex C).
Committee |
CEN/TC 343
|
DevelopmentNote |
Supersedes CEN/TS 15411 and PREN 15411. (09/2011)
|
DocumentType |
Standard
|
PublisherName |
Comite Europeen de Normalisation
|
Status |
Current
|
Supersedes |
Standards | Relationship |
DIN EN 15411:2011-11 | Identical |
NEN EN 15411 : 2011 | Identical |
PN EN 15411 : 2011 | Identical |
UNE-EN 15411:2012 | Identical |
NS EN 15411 : 2011 | Identical |
UNI EN 15411 : 2011 | Identical |
NBN EN 15411 : 2011 | Identical |
SN EN 15411 : 2011 | Identical |
NF EN 15411 : 2011 | Identical |
I.S. EN 15411:2011 | Identical |
BS EN 15411:2011 | Identical |
I.S. EN 15413:2011 | SOLID RECOVERED FUELS - METHODS FOR THE PREPARATION OF THE TEST SAMPLE FROM THE LABORATORY SAMPLE |
UNI EN 15442 : 2011 | SOLID RECOVERED FUELS - METHODS FOR SAMPLING |
NF EN 15359 : 2011 | SOLID RECOVERED FUELS - SPECIFICATIONS AND CLASSES |
I.S. EN 15359:2011 | SOLID RECOVERED FUELS - SPECIFICATIONS AND CLASSES |
EN 15413:2011 | Solid recovered fuels - Methods for the preparation of the test sample from the laboratory sample |
DIN EN 15410:2011-11 | Solid recovered fuels - Method for the determination of the content of major elements (Al, Ca, Fe, K, Mg, Na, P, Si, Ti) |
DIN EN 15408:2011-05 | Solid recovered fuels - Methods for the determination of sulphur (S), chlorine (Cl), fluorine (F) and bromine (Br) content |
XP T47 765 : 2011 XP | END OF LIFE TYRES (ELT) - CHARACTERISATION OF GRANULATES FROM GRANULATION PROCESSES - GUIDANCE FOR A TESTING CAMPAIGN |
UNI EN 15413 : 2011 | SOLID RECOVERED FUELS - METHODS FOR THE PREPARATION OF THE TEST SAMPLE FROM THE LABORATORY SAMPLE |
DIN EN 15359:2012-01 | Solid recovered fuels - Specifications and classes |
UNE-EN 15408:2011 | Solid recovered fuels - Methods for the determination of sulphur (S), chlorine (Cl), fluorine (F) and bromine (Br) content |
UNI EN 15359 : 2011 | SOLID RECOVERED FUELS - SPECIFICATIONS AND CLASSES |
UNI EN 15410 : 2011 | SOLID RECOVERED FUELS - METHODS FOR THE DETERMINATION OF THE CONTENT OF MAJOR ELEMENTS (AL, CA, FE, K, MG, NA, P, SI, TI) |
BS EN 15413:2011 | Solid recovered fuels. Methods for the preparation of the test sample from the laboratory sample |
UNE-EN 15359:2012 | Solid recovered fuels - Specifications and classes |
DIN EN 15407:2011-05 | Solid recovered fuels - Methods for the determination of carbon (C), hydrogen (H) and nitrogen (N) content |
BS EN 15359:2011 | Solid recovered fuels. Specifications and classes |
I.S. EN 15410:2011 | SOLID RECOVERED FUELS - METHODS FOR THE DETERMINATION OF THE CONTENT OF MAJOR ELEMENTS (AL, CA, FE, K, MG, NA, P, SI, TI) |
UNE-EN 15407:2011 | Solid recovered fuels - Methods for the determination of carbon (C), hydrogen (H) and nitrogen (N) content |
UNE-EN 15413:2012 | Solid recovered fuels - Methods for the preparation of the test sample from the laboratory sample |
UNE-EN 15442:2012 | Solid recovered fuels - Methods for sampling |
UNE-EN 15410:2012 | Solid recovered fuels - Methods for the determination of the content of major elements (Al, Ca, Fe, K, Mg, Na, P, Si, Ti) |
EN 15359:2011 | Solid recovered fuels - Specifications and classes |
EN 15357:2011 | Solid recovered fuels - Terminology, definitions and descriptions |
EN 15407:2011 | Solid recovered fuels - Methods for the determination of carbon (C), hydrogen (H) and nitrogen (N) content |
CEN/TS 15412:2010 | Solid recovered fuels - Methods for the determination of metallic aluminium |
EN 15414-3:2011 | Solid recovered fuels - Determination of moisture content using the oven dry method - Part 3: Moisture in general analysis sample |
EN 15442:2011 | Solid recovered fuels - Methods for sampling |
EN 15443:2011 | Solid recovered fuels - Methods for the preparation of the laboratory sample |
EN 15403:2011 | Solid recovered fuels - Determination of ash content |
EN 15408:2011 | Solid recovered fuels - Methods for the determination of sulphur (S), chlorine (Cl), fluorine (F) and bromine (Br) content |
EN 15410:2011 | Solid recovered fuels - Methods for the determination of the content of major elements (Al, Ca, Fe, K, Mg, Na, P, Si, Ti) |
ISO 5725-2:1994 | Accuracy (trueness and precision) of measurement methods and results Part 2: Basic method for the determination of repeatability and reproducibility of a standard measurement method |
ISO 3696:1987 | Water for analytical laboratory use — Specification and test methods |
EN ISO 3696:1995 | Water for analytical laboratory use - Specification and test methods (ISO 3696:1987) |
EN 13656:2002 | Characterization of waste - Microwave assisted digestion with hydrofluoric (HF), nitric (HNO3) and hydrochloric (HCl) acid mixture for subsequent determination of elements |
ISO 17294-2:2016 | Water quality — Application of inductively coupled plasma mass spectrometry (ICP-MS) — Part 2: Determination of selected elements including uranium isotopes |
EN ISO 17294-2:2016 | Water quality - Application of inductively coupled plasma mass spectrometry (ICP-MS) - Part 2: Determination of selected elements including uranium isotopes (ISO 17294-2:2016) |
EN 15413:2011 | Solid recovered fuels - Methods for the preparation of the test sample from the laboratory sample |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.