DEFSTAN 02-718/1(2002) : 2002
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
REQUIREMENTS FOR SEWAGE PLANT AND ANCILLARY EQUIPMENT IN HM SURFACE SHIPS AND SUBMARINES
23-07-2013
12-01-2013
TITLE PAGE
SCOPE
FOREWORD
Sponsorship
Conditions of Release
Categories of Naval Defence Standard
Related Documents
Health and Safety
Additional Information
CONTENTS
SECTION 1. PERFORMANCE SPECIFICATION
1.1 General Requirements
1.2 Plant Loading
1.3 Disinfection Equipment and Systems
1.4 Discharge Performance
1.5 Grey Waters
1.6 Food Waste
1.7 Reliability
SECTION 2. NATIONAL/INTERNATIONAL REGULATIONS
2.1 Certification
2.2 Safety
SECTION 3. MILITARY STANDARDS/REQUIREMENTS
3.1 Environmental Conditions
3.2 Drawing and Documentation
3.3 Plants and Systems Designed by the
Defence Procurement Agency
3.4 Plants and Systems Designed for the
Defence Procurement Agency
3.5 Electrical Requirements
3.6 Tanks
3.7 Cleaning and Preservation
3.8 Tests and Trials
3.9 Sampling
3.10 Lubrication
SECTION 4. DESIGN REQUIREMENTS/GUIDANCE
4.1 Sewage Systems
4.2 Sewage Plants and Tanks
4.3 Discharge/Transfer Systems
4.4 Installation at Ship
4.5 Tanks General Requirements
4.6 Filtration and Separation Arrangements
4.7 Flushing Systems
4.8 Vacuum Collection Systems
4.9 Air Supplies
4.10 Venting
Figure 4.1 Weatherdeck Terminal for Vent Pipes
4.11 Pumps
4.12 Macerators
4.13 Discharge Connection Points
4.14 Drains
Figure 4.2 Guards for Hangar and Vehicle Deck Drains
4.15 Pipework
4.16 Valves and Orifice Plates
4.17 Material
Table 4.1 List of Approved Materials
4.18 Underwater Openings Protection against Sabotage
4.19 Preservation of Strength and Watertight Integrity
4.20 Safety
4.21 Shipping and Securing
4.22 Identification/Modification Labelling
4.23 Alarms Warnings and Indications
4.24 Controls
4.25 Maintenance Requirements
SECTION 5. CORPORATE KNOWLEDGE & EXPERIENCE
5.1 Foaming
5.2 Vacuum Systems
5.3 Pipework Tables
Table 5.1 Allowable Fluid Speeds in
Pressure Discharge Pipes
Table 5.2 Discharge Unit and Minimum Drain Sizes for
Single Appliance
Table 5.3 Drains with a Declivity of Not Less than 1
in 30
5.4 Collect Hold and Transfer Plant
ANNEX A. RELATED DOCUMENTS
ANNEX B. ABBREVIATIONS AND DEFINITIONS
ANNEX C. PROCUREMENT CHECK LIST
ALPHABETICAL INDEX
Defines the general requirements for the collection, treatment and disposal of sewage, grey water, food slurry, wash water and loose water from decks.
DevelopmentNote |
Supersedes DEFSTAN 02-718(PT1)/1(2000), DEFSTAN 02-718(PT2)/1(2000), DEFSTAN 02-718(PT3)/1(2000), DEFSTAN 02-718(PT4)/1(2000), DEFSTAN 02-718(PT5)/1(2000), DEFSTAN 02-718(PT6)/1(2000) & DEFSTAN 02-718(PT7)/1(2000) (06/2003) This standard is obsolescent because it is no longer required for procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (07/2012)
|
DocumentType |
Standard
|
PublisherName |
UK Ministry of Defence Standards
|
Status |
Withdrawn
|
Supersedes |
DEFSTAN 02-106(PT1)/2(2010) : 2010 | REQUIREMENTS FOR MEDICAL & DENTAL ORGANIZATION IN HM SURFACE SHIPS AND SUBMARINES - PART 1: COMMON REQUIREMENTS - MEDICAL & DENTAL FACILITIES |
DEFSTAN 02-362/1(2000) : 2000 | TYPE AND PRODUCTION TESTING OF MECHANICAL EQUIPMENT |
DEFSTAN 02-853(PT1)/1(2000) : 2000 | REQUIREMENTS FOR THE IDENTIFICATION, COLOUR CODING AND MARKING FOR SYSTEMS - PART 1: SURFACE SHIPS CATEGORY 2 |
DEFSTAN 02-720/1(2000) : 2000 | WASTE DISPOSAL POLICY |
DEFSTAN 02-155(PT1)/1(2000) : 2000 | REQUIREMENTS FOR STRUCTURAL PRACTICES IN STEEL SURFACE SHIPS - PART 1: GENERAL REQUIREMENTS |
DEFSTAN 07-251/1(2000) : 2000 | REQUIREMENTS FOR THE PRESERVATION AND PAINTING OF COMPARTMENTS IN SURFACE SHIPS - CATEGORY 2 |
DEFSTAN 02-862(PT2)/1(2000) : 2000 | FASTENERS - PART 2: FERROUS |
BS 5391-1:1976 | Specification for acrylonitrile-butadiene-styrene (ABS) pressure pipe Pipe for industrial uses |
DEFSTAN 02-635/1(2000) : 2000 | REQUIREMENTS FOR ELECTRIC MOTORS AND CONTROL GEAR ASSOCIATED WITH DOMESTIC WORKSHOPS AND SIMILAR MACHINERY CATEGORY 3 |
DEFSTAN 02-599/1(2000) : 2000 | POLICY REQUIREMENTS AND DESIGN GUIDANCE FOR ALARM AND WARNING SYSTEMS CATEGORY N/A |
DEFSTAN 08-123/1(2000) : 2000 | REQUIREMENTS FOR THE DESIGN AND TESTING OF EQUIPMENTS TO MEET ENVIRONMENTAL CONDITIONS - CATEGORY 2 |
DEFSTAN 02-32/1(2000) : 2000 | REQUIREMENTS FOR ARRANGING AND CONDUCTING INSPECTIONS & TRIALS DURING THE CONSTRUCTION AND CONVERSION OF SURFACE SHIPS |
DEFSTAN 07-226/2(2001) : 2001 | REQUIREMENTS FOR ELECTRICAL TESTING OF EQUIPMENT - CATEGORY 2 |
BS 7372-1:1991 | Guide to the choice of aperture size and wire diameter combinations for industrial wire screens and woven wire cloth General |
DEFSTAN 02-327/2(2001) : INTERIM | REQUIREMENTS AND GUIDANCE FOR THE PROCUREMENT OF PUMPS FOR AUXILIARY SYSTEMS |
DEFSTAN 02-120/1(2000) : 2000 | REQUIREMENTS FOR WCS, URINALS, BATHROOMS & WASHING FACILITIES |
DEFSTAN 02-723/1(2000) : 2000 | REQUIREMENTS FOR MARKER PLATES |
DEFSTAN 02-862(PT3)(2000) : 2000 | FASTENERS - PART 3: NON-FERROUS FASTENERS CATEGORY 2 |
BS 5392-1:1976 | Specification for acrylonitrile-butadiene-styrene (ABS) fittings for use with ABS pressure pipe Fittings for use with pipe for industrial uses |
DEFSTAN 02-707(PT2)/1(2000) : 2000 | SYMBOLS AND ABBREVIATIONS - PART 2: GUIDE TO ABBREVIATIONS AND SYSTEM CODE LETTERS |
DEFSTAN 02-127/1(2000) : 2000 | ACCESS FITTINGS AND EQUIPMENT |
DEFSTAN 02-40(PT1)/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION OF TECHNICAL PUBLICATIONS - PART 1: SYSTEM AND EQUIPMENT PUBLICATIONS CATEGORY 2 |
BS 3399:1961 | Specification for transformers for use in ships |
BS 4346-1:1969 | Joints and fittings for use with unplasticized PVC pressure pipes Injection moulded unplasticized PVC fittings for solvent welding for use with pressure pipes, including potable water supply |
DEFSTAN 08-107/2(2001) : 2001 | GENERAL REQUIREMENTS FOR THE DESIGN OF ELECTROMECHANICAL AND NAVAL WEAPON EQUIPMENT - CATEGORY 2 |
DEFSTAN 02-719/1(2000) : 2000 | SEA WATER SYSTEMS FOR HM SURFACE SHIPS CATEGORY 2 |
DEFSTAN 02-40(PT3)/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION OF TECHNICAL PUBLICATIONS - PART 3: ENGINEERING MANUALS CATEGORY 2 |
DEFSTAN 02-722/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION, IDENTIFICATION AND MANAGEMENTS OF DRAWINGS |
DEFSTAN 05-10/4(1990) : 1990 | DRAWING PROCEDURE |
BS EN 1514-1:1997 | Flanges and their joints. Dimensions of gaskets for PN-designated flanges Non-metallic flat gaskets with or without inserts |
DEFSTAN 02-853(PT2)/1(2000) : 2000 | REQUIREMENTS FOR THE IDENTIFICATION, COLOUR CODING AND MARKING FOR SYSTEMS - PART 2: SUBMARINES CATEGORY 2 |
DEFSTAN 02-862(PT5)(2000) : 2000 | FASTENERS - PART 5: NON-FERROUS (SUBMARINE FIRST LEVEL QUALITY ASSURED) CATEGORY 2 |
DEFSTAN 02-703/1(2000) : 2000 | THERMAL AND ACOUSTIC INSULATION OF HULL AND MACHINERY |
DEFSTAN 02-374/1(2000) : 2000 | RUBBER FLEXIBLE PIPES AND BELLOWS FOR USE IN SUBMARINES CATEGORY 2 |
DEFSTAN 59-41(PT1)/4(1988) : 1988 | ELECTROMAGNETIC COMPATIBILITY - PART 1: GENERAL REQUIREMENTS |
DEFSTAN 02-862(PT1)/1(2000) : 2000 | FASTENERS - PART 1: GENERAL |
DEFSTAN 07-252/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION AND PAINTING OF SUBMARINES - CATEGORY 2 |
DEFSTAN 02-315/2(2002) : 2002 | AIR COMPRESSORS CATEGORY 2 |
DEFSTAN 02-345/1(2000) : 2000 AMD 1 2002 | REQUIREMENTS FOR FLEXIBLE RUBBER PIPE ASSEMBLIES AND BELLOWS FOR USE IN SYSTEMS FROM VACUUM TO 10 BAR |
DEFSTAN 02-707(PT1)/1(2000) : 2000 | SYMBOLS AND ABBREVIATIONS - PART 1: GUIDE TO THE GENERAL USE OF SYMBOLS |
DEFSTAN 02-23/2(2001) : 2001 | REQUIREMENTS FOR THE ORGANIZATION OF TESTS AND TRIALS DURING THE CONSTRUCTION AND CONVERSION OF SURFACE SHIPS |
DEFSTAN 01-5/13(2002) : 2002 | FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS |
DEFSTAN 02-360/1(2000) : 2000 | LIST OF PREFERRED STANDARD VALVES (METRIC) (LOW PRESSURE) |
DEFSTAN 02-40(PT4)/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION OF TECHNICAL PUBLICATIONS - PART 4: SHIP NBCD CLASS BOOKS AND SHIP STABILITY AND SURVIVABILITY BOOKS |
DEFSTAN 07-244/1(2000) : 2000 | REQUIREMENTS FOR AC AND DC MOTORS - CATEGORY 2 |
DEFSTAN 02-862(PT4)(2000) : 2000 | FASTENERS - PART 4: FERROUS (SUBMARINE FIRST LEVEL QUALITY ASSURED) CATEGORY 2 |
DEFSTAN 02-40(PT2)/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION OF TECHNICAL PUBLICATIONS - PART 2: WEAPON EQUIPMENT INSTALLATION SPECIFICATIONS CATEGORY 2 |
DEFSTAN 00-35/2(1996) : 1996 AMD 1 1997 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL |
DEFSTAN 02-502/1(2000) : 2000 | REQUIREMENTS FOR ELECTRICAL INSTALLATIONS CATEGORY 2 |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.