• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

BS ISO 16000-33:2017

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Indoor air Determination of phthalates with gas chromatography/mass spectrometry (GC/MS)

Available format(s)

Hardcopy , PDF

Superseded date

04-07-2024

Superseded by

BS ISO 16000-33:2024

Language(s)

English

Published date

25-08-2017

£276.00
Excluding VAT

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Sampling methods and analytical apparatus
5 Calibration
6 Identification and quantification
7 Establishment of calibration curves and calculation
   of the analyte mass
8 Calculation of indoor air concentrations
9 Performance characteristics
10 Quality assurance
11 Interferences
Annex A (informative) - General information on phthalates
Annex B (informative) - Screening phthalates in solvent wipe
        tests
Annex C (informative) - Screening phthalates in house dust
Annex D (informative) - Practical example for the calibration
        of the thermal desorption method
Annex E (informative) - Practical example for the calibration
        of the solvent extraction method using Florisil[R][2])
Annex F (informative) - Practical example for the gas
        chromatography with thermal desorption
Annex G (informative) - Practical example for the gas
        chromatography following solvent extraction
Annex H (informative) - Problems related to the blank
        values
Annex I (informative) - Example of a sampling protocol
Bibliography

Defines the sampling and analysis of phthalates in indoor air and describes the sampling and analysis of phthalates in house dust and in solvent wipe samples of surfaces by means of gas chromatography/mass spectrometry.

Committee
EH/2/5
DevelopmentNote
Supersedes 15/30286360 DC. (09/2017)
DocumentType
Standard
Pages
52
PublisherName
British Standards Institution
Status
Superseded
SupersededBy

This document specifies the sampling and analysis of phthalates in indoor air and describes the sampling and analysis of phthalates in house dust and in solvent wipe samples of surfaces by means of gas chromatography/mass spectrometry.

Two alternative sampling and processing methods, whose comparability has been proven in a round robin test, are specified for indoor air[4]. Sampling can take place using sorbent tubes with subsequent thermal desorption and GC-MS analysis. Alternatively, sampling can take on other types of sorbent tubes that are subsequently analysed by solvent extraction with GC-MS.

Depending on the sampling method, the compounds dimethyl phthalate to diisoundecylphthalate can be analysed in house dust as described in AnnexC[8]. The investigation of house dust samples is only appropriate as a screening method. This investigation only results in indicative values and is not acceptable for a final assessment of a potential need for action.

Dimethyl phthalate to diisoundecylphthalate can be analysed in solvent wipe samples as described in AnnexB. Solvent wipe samples are suitable for non-quantitative source identification.

NOTE In principle, the method is also suitable for the analysis of other phthalates, adipates and cyclohexane dicarboxylic acid esters, but this is confirmed by determination of the performance characteristics in each case.

General information on phthalates are given in Annex A.

Standards Relationship
ISO 16000-33:2017 Identical

ISO 16000-5:2007 Indoor air Part 5: Sampling strategy for volatile organic compounds (VOCs)
ISO 18856:2004 Water quality — Determination of selected phthalates using gas chromatography/mass spectrometry
ISO 16000-1:2004 Indoor air — Part 1: General aspects of sampling strategy
ISO 16000-6:2011 Indoor air Part 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TA sorbent, thermal desorption and gas chromatography using MS or MS-FID

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.