BS ISO 10816-5:2001
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Mechanical vibration. Evaluation of machine vibration by measurements on non-rotating parts Machine sets in hydraulic power and pumping plants
Hardcopy , PDF
24-07-2018
English
12-10-2001
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Machine arrangements
4 Measurement procedures and conditions
4.1 General
4.2 Measurement type
4.3 Measurement locations and directions
4.4 Measurement equipment
4.5 Operational conditions
5 Evaluation
5.1 General
5.2 Criterion I: Vibration magnitude
5.3 Evaluation zone limits
5.3.1 Turbine operating conditions
5.3.2 Pump operating conditions
5.3.3 Special conditions
5.3.4 Axial vibration
5.4 Criterion II: Change in vibration magnitude
5.5 Operational limits
5.5.1 General
5.5.2 Setting of ALARMS
5.5.3 Setting of TRIPS
5.5.4 Special operating conditions
5.6 Supplementary procedures/criteria
5.7 Evaluation based on vibration vector
information
Annex A (normative) Evaluation zone boundaries
Annex B (informative) Special features of bearing housing
vibration of hydraulic machine sets
Annex C (informative) Analysis procedure and applied
regression technique
Bibliography
Provides guidelines for application of bearing housing vibration evaluation criteria measured under normal operation conditions at the bearings, bearing pedestals or housings of the main machine sets in hydraulic power generating and pumping plants, given in terms of both steady-state running vibration and any amplitude changes occurring in these steady values. Applicable to machine sets in hydraulic power generating and pumping plants where the hydraulic machines have have speeds from 60 r/minute to 1800 r/minute, shell or shoe type sleeve bearings and a main engine power of 1 MW and more.
| Committee |
GME/21/5
|
| DevelopmentNote |
Supersedes 98/716323 DC. (10/2001)
|
| DocumentType |
Standard
|
| Pages |
28
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 10816-5:2000 | Identical |
| ISO 7919-1:1996 | Mechanical vibration of non-reciprocating machines Measurements on rotating shafts and evaluation criteria Part 1: General guidelines |
| ISO 7919-5:2005 | Mechanical vibration Evaluation of machine vibration by measurements on rotating shafts Part 5: Machine sets in hydraulic power generating and pumping plants |
| ISO 10816-1:1995 | Mechanical vibration Evaluation of machine vibration by measurements on non-rotating parts Part 1: General guidelines |
| ISO 2954:2012 | Mechanical vibration of rotating and reciprocating machinery — Requirements for instruments for measuring vibration severity |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.