BS EN 1776:2015

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Basic requirements for measuring systems
6 Energy Determination
7 Design of gas measuring system
8 Construction of a gas measuring installation
9 Testing of the gas measuring installation/station
10 Pre-commissioning and commissioning of the
   gas measuring installation
11 Operation and maintenance
12 Decommissioning
Annex A (informative) - Guideline for the selection of meters
Annex B (informative) - Sensor test procedures
Annex C (informative) - Set of formulae to calculate volume
        or mass to energy
Annex D (informative) - Comformity assessment for the
        energy determination
Annex E (informative) - Specific national examples of
        the assessment of conformityof the metrological
        performance of a gas measuring system
Annex F (informative) - Documentation and records
Annex G (informative) - Typical examples of positions of
        gas measuring installations
Annex H (informative) - Significant technical changes from
        the last edition of this standard, EN 1776:1998
Bibliography

Gives functional requirements for the design, construction, testing, commissioning/decommissioning, operation, maintenance and, where appropriate, calibration, together with suitable documented provisions for all new gas measuring systems and any major changes of existing systems.

This European Standard specifies functional requirements for the design, construction, testing, commissioning/decommissioning, operation, maintenance and, where appropriate, calibration, together with suitable documented provisions for all new gas measuring systems and any major changes of existing systems. This European Standard also specifies accuracy classes of measuring systems and thresholds applicable to these classes. Demonstration of compliance is achieved through the selection, installation and operation of appropriate measurement instruments, together with suitable documented provisions for calculations. Examples of demonstration of compliance are provided for each accuracy class; however, they are not prescriptive solutions. This European Standard is applicable for gases of the 2nd family as classified in EN437 . It is also applicable for treated non-conventional combustible gases complying with EN437 and for which a detailed technical evaluation of the functional requirements (such as injected biomethane) is performed ensuring there are no other constituents or properties of the gases that can affect the metrological and physical integrity of the measuring systems. This European Standard can also be used as a guideline for 1st and 3rd family gases as classified in EN437 ; however additional considerations should be taken with regard to the different constituents and physical characteristics of the gas family. This European Standard is not applicable for raw or sour gases. This European Standard is not applicable for gas measurement in CNG filling station. This European Standard gives guidelines when designing, installing and operating gas meters with additional functionalities (smart gas meters). Communication protocols and interfaces for gas meters and remote reading of gas meters are outside the scope of this European Standard and are covered by the appropriate parts of EN13757 , which provide a number of protocols for meter communications. Supervisory control and data acquisition protocols (SCADA) are also not covered by this European Standard. Unless otherwise specified all pressures used in this European Standard are gauge pressures. For associated pressure regulating systems the requirements of EN12186 and/or EN12279 apply. For requirements on design, housing, lay-out, materials for components, construction, ventilation, venting and overall safety of gas measuring systems within the scope of this European Standard, EN15001 , EN12186 , EN12279 and/or EN1775 apply additionally, where relevant. This European Standard specifies common basic principles for gas infrastructure. Users of this European Standard should be aware that more detailed national standards and/or codes of practice may exist in the CEN member countries. This European Standard is intended to be applied in association with these national standards and/or codes of practice setting out the above mentioned basic principles. In the event of conflicts in terms of more restrictive requirements in national legislation/regulation with the requirements of this European Standard, national legislation/regulation takes precedence as illustrated in CEN/TR13737‑1 and CEN/TR13737‑2 . CEN/TR13737 (all parts) gives: clarification of all legislation/regulations applicable in a member state; if appropriate, more restrictive national requirements; a national contact point for the latest information.